Sagaris door cap.
Discussion
I'll make you an offer
I posted this http://www.pistonheads.co.uk/gassing/topic.asp?h=0... two years ago
I posted this http://www.pistonheads.co.uk/gassing/topic.asp?h=0... two years ago
Good News for everyone ... Hot off the press .... SC Power are making the full range TVR range of door cappings.
http://www.sc-power.co.uk/index.html
http://www.sc-power.co.uk/index.html
glow worm said:
Good News for everyone ... Hot off the press .... SC Power are making the full range TVR range of door cappings.
http://www.sc-power.co.uk/index.html
Any news ?http://www.sc-power.co.uk/index.html
- push up*
Will they go for the Tamora ones, too ?
I'm always amused by the Trevor Cooper at TVR made the moulds for them.... Filling a rubber glove with silicon , then closing the door on the glove and waiting for it to set, thereby making the impression .
A bit like going to the dentist
A bit like going to the dentist
Edited by glow worm on Tuesday 27th September 12:03
I’ve spoken to a company who can scan them.
They need to scan a good example of each trim required. Only need to scan one side as they can be mirrored on Cad assuming they are symmetrical?
The image then needs to be cleaned up, to produce a parametric model. (Not 100% sure I know what this) With this file you can then print as many as you need forever.
The cost up front is not small but could be done if there was enough interest.
I am talking with a company that could print them in the correct material.
You would need to sell them in pairs O/S N/S with a minimum order of 7 pairs of each design to justify the scanning costs.
The cost would be slightly higher than they have been sold for in the past.
This information is all based on phone calls and photos, in reality things may change.
Would anyone be interested?
They need to scan a good example of each trim required. Only need to scan one side as they can be mirrored on Cad assuming they are symmetrical?
The image then needs to be cleaned up, to produce a parametric model. (Not 100% sure I know what this) With this file you can then print as many as you need forever.
The cost up front is not small but could be done if there was enough interest.
I am talking with a company that could print them in the correct material.
You would need to sell them in pairs O/S N/S with a minimum order of 7 pairs of each design to justify the scanning costs.
The cost would be slightly higher than they have been sold for in the past.
This information is all based on phone calls and photos, in reality things may change.
Would anyone be interested?
I can lend you two pairs (Drivers & Passenger Doors) for Tuscan Convertible and Chimaera . I also have the Tuscan vert inner moulding for the drivers door. Email me if you want them.
As I said Tamora and Sag are different and I'm not sure about a T350.
As I said Tamora and Sag are different and I'm not sure about a T350.
Edited by glow worm on Tuesday 27th September 17:36
Gassing Station | Tamora, T350 & Sagaris | Top of Page | What's New | My Stuff