Need a fabricatior / somebody to get a project over the line

Morning all,

Posting for a friend who isn't on PH. Looking for recommendations for someone to get the following project finished:

He's got a Mk1 TT 3.2 V6, which is part way through a Rotrex supercharger conversion. He's now working long hours and is also basically stuck on a few hurdles.

It needs various boost pipes / intake pipes fabricating and squirreling away behind the front bumper (space is tight!). It also needs a new crossmember fabricating (OEM one hits the charger). Intercooler mounting and piping in. Uprated fuel pump. Wideband lambda sensor fitting. You get the gist of it. Finally it needs mapping (likely by a third party) and an MOT.

Looking for recommendations for someone with fabrication experience and project-finishing experience . He's Derby based, so ideally within the Midlands.

Thanks

or a couple of googles ?

https://forum.retro-rides.org/thread/153411/fabric...

https://racinglines.co.uk/about/

perhaps an appropriate forum to ask too

https://www.mig-welding.co.uk/forum/

That job list is going to need a lot of the same skills that motorsport teams would use. I suggest you look around your region for any low budget motorsport teams to see if any are interested in bringing in a little extra cash during the off season.

Thank you so much for the link.