Clutch hydraulics not working after rebuild
Discussion
After leaving the master cylinder leak for way too long I have now had it off the car and put new seals in.
I also had the slave off and honed the bore slightly to remove some light rust.
Now I have put it all back together and bled it through (assistant up-down open-close method) but there is NO resistance in the pedal.
Anything obvious I am missing? Is it really tricky to bleed the Griff from empty? Could I have missed something rebuilding the cylinders ?
Going to go get an EzzeBleed in the morning and try that.
As an aside to the post, here is the spanner I 'made' to get on the bottom bolt - used blowlamp and a BIG hammer :-)
I also had the slave off and honed the bore slightly to remove some light rust.
Now I have put it all back together and bled it through (assistant up-down open-close method) but there is NO resistance in the pedal.
Anything obvious I am missing? Is it really tricky to bleed the Griff from empty? Could I have missed something rebuilding the cylinders ?
Going to go get an EzzeBleed in the morning and try that.
As an aside to the post, here is the spanner I 'made' to get on the bottom bolt - used blowlamp and a BIG hammer :-)
Gassing Station | Griffith | Top of Page | What's New | My Stuff