Is this correct?
Discussion
No raised thread issues and it is definitely 7/16" UNF.
The only query now is this; when I tried to tighten the nut, the spigot(?) on the ball joint (the bit that goes into the arm on the upright) turned as well ponce the nylon collar bit. I put a jack under the ball joint so it was under a little bit of tension and the nut tightened up. Is this normal?
The only query now is this; when I tried to tighten the nut, the spigot(?) on the ball joint (the bit that goes into the arm on the upright) turned as well ponce the nylon collar bit. I put a jack under the ball joint so it was under a little bit of tension and the nut tightened up. Is this normal?
Gassing Station | S Series | Top of Page | What's New | My Stuff