Rather pleased with these.
Discussion
Thanks chaps.
v8s4me - They were done by none of the usual suspects because they are not veneered. In my opinion glueing two materials which are going to respond vastly differently to thermal and atmospheric conditions is doomed to fail, as mine did, resulting in cracking and peeling. It is also quite expensive, this wasn't.
I decided to take a chance and try having them hydro dipped/water transfer printed. As this method is used for three dimensional objects it means that the door card trims match the dash fascia and switch panel properly, (they were originally hand painted).
In answer to your question, they were done by Monkeyfinger Custom Paint of Knottingley. The guys there were really good and put a lot of effort into getting the colouring and tones as I wanted them.
GreenV8S - Yeah, thanks, I am aware and will wave the vernier at them before refitting.
fozzy280472 - No I didn't take any material off. It was a pig to get out and no doubt will be the same to put back. I did consider it but decided that, it fit before and it came out so it will go back.
Cheers,
Carl.
v8s4me - They were done by none of the usual suspects because they are not veneered. In my opinion glueing two materials which are going to respond vastly differently to thermal and atmospheric conditions is doomed to fail, as mine did, resulting in cracking and peeling. It is also quite expensive, this wasn't.
I decided to take a chance and try having them hydro dipped/water transfer printed. As this method is used for three dimensional objects it means that the door card trims match the dash fascia and switch panel properly, (they were originally hand painted).
In answer to your question, they were done by Monkeyfinger Custom Paint of Knottingley. The guys there were really good and put a lot of effort into getting the colouring and tones as I wanted them.
GreenV8S - Yeah, thanks, I am aware and will wave the vernier at them before refitting.
fozzy280472 - No I didn't take any material off. It was a pig to get out and no doubt will be the same to put back. I did consider it but decided that, it fit before and it came out so it will go back.
Cheers,
Carl.
Edited by Ceejay73 on Thursday 19th May 10:20
Oldred_V8S said:
They look fantastic. Do you recall what colour/tones they used? THis looks to match mine. I need to get mine done, they are perfect apart from having cracked in one place after we parked in 37 degree heat in Germany.
There are many different films out there from different suppliers, I spent hours looking at different walnut patterns, ( I think I may have gone just a little strange ).In the end I selected a film from Hugas Ltd. I am fairly sure it was Walnut Brown V2 50.
The film was applied over a white basecoat.
It was then given a light coat of candy copper in order to achieve the rich red tones that I wanted.
Finally lacquered, flatted and polished.
Gassing Station | S Series | Top of Page | What's New | My Stuff