PCV. IDLING PROBLEMS

[dubc223]

I have really bad idling problems and have found that its my pcv valve/or not. I removed the pipe and valve and all seems free and working well.

When i place my finger over the pipe leading to the intake manifold it sucks which it should do.
However if i place my finger over the pcv chamber(which leads to the head) it also sucks. (So these two are pushing against each other)

Can anybody tell me if this sounds like a problem with the chamber or any suggestions at all.

When i place the pipe into the intake manifold and into the PCv chamber and run my car i get a vacuum in the engine.(NOT GOOD). It seems as if there's a block somewhere but as i've said the PCV valve seems in perfect working order........

Any help would be greatly appreciated

Cheers
Dave

[dubc223]

Have already put it in general and didn't get a reply so had to try something....

Its a 1999 1.8 Standard Honda Integra type R

[dubc223]

I've tried it under revs too and it also does the same. If i attatch the pcv valve into the chamber and into the intake manifold the car works perfect UNTIL..About 30 secs of running the car it makes a loud whirring noise and theres a lot of pressure being built up in the engine which leads me to think there may be a block somewhere??????????

[dubc223]

I've tried it under revs too and it also does the same. If i attatch the pcv valve into the chamber and into the intake manifold the car works perfect UNTIL..About 30 secs of running the car it makes a loud whirring noise and theres a lot of pressure being built up in the engine which leads me to think there may be a block somewhere??????????