V6 cooling system
Discussion
I'm doing my first coolant change and dropped the bottom radiator hose on my '84 280i. I only got around 3ltrs of old coolant out.
Presumably this is because the thermostat housing is at the bottom of the engine and was closed when I tried to drain the system.
All I drained was the contents of the radiator so can someone tell me if it is necessary to pull off the thermostat housing to drain the block?
I can't believe this is the only way to fully drain the coolant.
Steve's book does not shed any light so I'm thinking I'm missing something simple....
I'm hesitant to let the car idle until the thermostat opens releasing the rest of the coolant so what's the answer.
I've phoned a friend without success so now I'm going to the audience.......
Presumably this is because the thermostat housing is at the bottom of the engine and was closed when I tried to drain the system.
All I drained was the contents of the radiator so can someone tell me if it is necessary to pull off the thermostat housing to drain the block?
I can't believe this is the only way to fully drain the coolant.
Steve's book does not shed any light so I'm thinking I'm missing something simple....
I'm hesitant to let the car idle until the thermostat opens releasing the rest of the coolant so what's the answer.
I've phoned a friend without success so now I'm going to the audience.......
280 you've given me hope. Where exactly was the plug you found? Presume I'm looking for something resembling a sump plug?
Another reason for staying away from the thermostat is that the original housing was rotten and a replacement was manufactured from steel last year. When fitted they used blue gunk of some sort instead of a gasket.
Therefore I won't get a gasket to fit and will have to cut one etc etc...
Cheers.
Another reason for staying away from the thermostat is that the original housing was rotten and a replacement was manufactured from steel last year. When fitted they used blue gunk of some sort instead of a gasket.
Therefore I won't get a gasket to fit and will have to cut one etc etc...
Cheers.
Coolant was looking rusty and It's summer in Aust so I decided to do the deed.
I have improvised and taken the advice of one of the above posts.
Took off the hose into the thermostat housing from the engine. Blocked all other holes incl radiator and pushed water hose into the housing. Flushed it out nicely. Actually blew into the hose to ensure no water left in system ( nice oily smile now...)then sealed all up and added the coolant. It took about 6.5 litres which sounds right as I have bypassed the heater.
Until proven wrong I am firmly of the opinion my engine does not have any drain plugs.
Thanks to all for your advice. "Darling, I just have to take the car for a run to check for leaks...."
I have improvised and taken the advice of one of the above posts.
Took off the hose into the thermostat housing from the engine. Blocked all other holes incl radiator and pushed water hose into the housing. Flushed it out nicely. Actually blew into the hose to ensure no water left in system ( nice oily smile now...)then sealed all up and added the coolant. It took about 6.5 litres which sounds right as I have bypassed the heater.
Until proven wrong I am firmly of the opinion my engine does not have any drain plugs.
Thanks to all for your advice. "Darling, I just have to take the car for a run to check for leaks...."
Gassing Station | Wedges | Top of Page | What's New | My Stuff