Replacement engine
Discussion
Guys after looking around for replacement engines for my 350, I have found a few 400 / 450 from Chims etc.
Would there be much work to do to make fit due to serpentine pulleys, stripping manifolds of etc, has anyone on here done this.
Yes I already have SEAC front brakes and uprated suspension, would need new rear disk, bigger drive shafts from somewhere ( as mine apparently are the smaller ones) Would cooling be a prob - just replaced to a new single fan any other probs for DIYer ?
Would there be much work to do to make fit due to serpentine pulleys, stripping manifolds of etc, has anyone on here done this.
Yes I already have SEAC front brakes and uprated suspension, would need new rear disk, bigger drive shafts from somewhere ( as mine apparently are the smaller ones) Would cooling be a prob - just replaced to a new single fan any other probs for DIYer ?
Cheers for all the info guys
Found a low milage 4.0 pre serp for a reasonable price including injection,ecu,afm and loom,so it sounds as if this will be the easier way to go. not quite a bbw bit must be a bit better than a 3.5 at present. - I have a later type (89) so A frame should cope as well and everything else won't be too stressed out hopefully
Cheers
Found a low milage 4.0 pre serp for a reasonable price including injection,ecu,afm and loom,so it sounds as if this will be the easier way to go. not quite a bbw bit must be a bit better than a 3.5 at present. - I have a later type (89) so A frame should cope as well and everything else won't be too stressed out hopefully
Cheers
Gassing Station | Wedges | Top of Page | What's New | My Stuff