TVR branded brakes
Discussion
JR said:
This may be of interest:
Does this mean Wilwood and AP do a rear caliper with handbrake, or is Steve refering to just a front calliper upgrade?shpub said:
I've since used Wilwood and Hi spec but I am looking now to going to AP. Wilwood were fine and were transferred to my Griff. I had some problems with the Hispec set up with internal seals failing causing random blockages. One caused the car to go into a tyre barrier at Hethel under heavy braking as the caliper seized on one side. Took some sorting out. My overall experience of Hispec have not been good. The braking setup I have achieves 1.1g.
HTR !
I need to replace my discs (on Uncle Festers old Griff)- 300mm (28mm thick) vented,grooved on Tuscan AP Racing callipers but disc has 10 mounting holes and I can't source - any help appreciated if any of you guys recall make/spec if bought following this thread..... regards, Paul.
I need to replace my discs (on Uncle Festers old Griff)- 300mm (28mm thick) vented,grooved on Tuscan AP Racing callipers but disc has 10 mounting holes and I can't source - any help appreciated if any of you guys recall make/spec if bought following this thread..... regards, Paul.
HTR !
I need to replace my discs (on Uncle Festers old Griff)- 300mm (28mm thick) vented,grooved on Tuscan AP Racing callipers but disc has 10 mounting holes and I can't source - any help appreciated if any of you guys recall make/spec if bought following this thread..... regards, Paul.
I need to replace my discs (on Uncle Festers old Griff)- 300mm (28mm thick) vented,grooved on Tuscan AP Racing callipers but disc has 10 mounting holes and I can't source - any help appreciated if any of you guys recall make/spec if bought following this thread..... regards, Paul.
pjac67 said:
HTR !
I need to replace my discs (on Uncle Festers old Griff)- 300mm (28mm thick) vented,grooved on Tuscan AP Racing callipers but disc has 10 mounting holes and I can't source - any help appreciated if any of you guys recall make/spec if bought following this thread..... regards, Paul.
It looks like Uncle Fester ditched the Hi Spec idea an purchased that kit from Hans in the picture. Might be worth contacting Hans by PM on here hansdaalI need to replace my discs (on Uncle Festers old Griff)- 300mm (28mm thick) vented,grooved on Tuscan AP Racing callipers but disc has 10 mounting holes and I can't source - any help appreciated if any of you guys recall make/spec if bought following this thread..... regards, Paul.
Gassing Station | General TVR Stuff & Gossip | Top of Page | What's New | My Stuff