Talk to me about CH timers/stats!
Discussion
The Wolfhound said:
Any complications/issues with the wiring that I would need to be aware of pse?
TVM
No. It'll have an L N E in and the same out. Make sure you have tyhem the right way 'round and all will be well.TVM
It may even have common terminals for N and E and an L in and an L out.
Ferg said:
The Wolfhound said:
Any complications/issues with the wiring that I would need to be aware of pse?
TVM
No. It'll have an L N E in and the same out. Make sure you have tyhem the right way 'round and all will be well.TVM
It may even have common terminals for N and E and an L in and an L out.
Ferg Hi again!!!
Can I ask you to have a looksee at the link ( http://www.screwfix.com/sfd/i/cat/pdfs/44/p4764244... )and put the wiring part of it into laymans terms when you have 5 mins pse? Thanks again...
Can I ask you to have a looksee at the link ( http://www.screwfix.com/sfd/i/cat/pdfs/44/p4764244... )and put the wiring part of it into laymans terms when you have 5 mins pse? Thanks again...
The Wolfhound said:
Ferg Hi again!!!
Can I ask you to have a looksee at the link ( http://www.screwfix.com/sfd/i/cat/pdfs/44/p4764244... )and put the wiring part of it into laymans terms when you have 5 mins pse? Thanks again...
Live and Neutral are the power coming in to the timer.Can I ask you to have a looksee at the link ( http://www.screwfix.com/sfd/i/cat/pdfs/44/p4764244... )and put the wiring part of it into laymans terms when you have 5 mins pse? Thanks again...
The neutral for the water heater comes from the same neutral.
The live for the water heater comes from the 'NO' (Normally Open) terminal.
You must put live into the 'COM' (Common) terminal.
It may help to put a junction box of some sort on the wall. Just to have some terminal strip to wire to.
If you use that diagram that says 'Single Power Supply', the circle with a big 'X' in represents the water heater with a Live in one side and a Neutral in the other.
Is that clear? Mail me if not.
Edited by Ferg on Wednesday 2nd June 06:38
Swoxy said:
CM907. Am I doing this right? I don't think I am. I don't have any other wires. Thanks ...
Spot on. The little box in the diagram is the boiler. N to one side of it the live from B on the switch to the other. You could do with some brown phase sleeve over the blue to identify it, that's all.(Assuming those two conductors need joining to fire the boiler!!)Edited by Ferg on Saturday 31st March 14:56
Gassing Station | Homes, Gardens and DIY | Top of Page | What's New | My Stuff