Is this fixable?
Discussion
I'm getting my place ready for renting and the patio doors don't lock. The key goes in and turn clockwise, but not all the way round to enable it to lock. The actual handle/lever to lock the door from being opened does work, but the barrel/lock doesn't. I hope that makes sense...
My question is, is the patio door too old to buy a new barrel lock, and possibly renew the handle and lever (although the lever works, it's a bit notchy) and fix the issue? Or am I looking at putting in a new patio door?
Frame
Thanks in advance for any info!
Cad
My question is, is the patio door too old to buy a new barrel lock, and possibly renew the handle and lever (although the lever works, it's a bit notchy) and fix the issue? Or am I looking at putting in a new patio door?
Frame
Thanks in advance for any info!
Cad
I've just taken out the barrel and it turns freely 360 degrees. Once you put it back into the door, It stops in the same place.
So the tab/bar thing in the barrel isn't lining up with what ever's in the door (which you can't get to). I've taken the handle off and the lever stays in place, but there's not way of getting to the inner workings inside the door. It's almost like you'd have to take the door out to get to the mechanism from the top or bottom with a coat hanger or something
The only screws (apart from the barrel) inside the length of the sliding door, are the 3 sets of screws for the locking bars/tabs that move up and down when you lift or lower the lever
Thanks for the replies so far chaps.
So the tab/bar thing in the barrel isn't lining up with what ever's in the door (which you can't get to). I've taken the handle off and the lever stays in place, but there's not way of getting to the inner workings inside the door. It's almost like you'd have to take the door out to get to the mechanism from the top or bottom with a coat hanger or something
The only screws (apart from the barrel) inside the length of the sliding door, are the 3 sets of screws for the locking bars/tabs that move up and down when you lift or lower the lever
Thanks for the replies so far chaps.
eatontrifles said:
Surely just means the barrel/cylinder is mismatched to the door & you need to measure up and get a replacement cylinder that matches
No. This is the barrel tha's been with the door, when it was working before.eatontrifles said:
If you remove the screw and wiggle backwards or forwards does it work?
No. not in any combination. Door open, closed, latch up, latch down, central...eatontrifles said:
Is the barrel fitted backwards?
No. It's fitted correctly.Gassing Station | Homes, Gardens and DIY | Top of Page | What's New | My Stuff