£3.49 for 12BHP anyone?
£3.49 for 12BHP anyone?
Author
Discussion

lockstock2sb

Original Poster:

2,855 posts

274 months

Saturday 11th March 2006
quotequote all
i know its been done before - but this guy has his picture up on there ! Just so you can see who's fleecing you !

http://cgi.ebay.co.uk/UPGRADE-MOD-5-2

Witchfinder

6,388 posts

283 months

Saturday 11th March 2006
quotequote all
And if anyone's dumb enough to fit a resistor, then I've got an electric supercharger I can sell you. Runs off the cigarette lighter socket

r5gttgaz

7,897 posts

251 months

Saturday 11th March 2006
quotequote all




works a treat 0-60 down from 11.3 to 8.2 (fiat punto cabrio) A*
Buyer rachael19710 ( 27 )
23-Sep-05 19:04
7999780162

moleamol

15,887 posts

294 months

Saturday 11th March 2006
quotequote all
And I've got some turbos, you just pop them in the exhaust and the suck air out, same effect as one on the engine sucking air in.

I actually think those would sell on eBay.

nightdriver

1,082 posts

257 months

Saturday 11th March 2006
quotequote all
dumb eBayer said:
cool little thing car seems to breath better


Yep, those resistors really help the engine breath!!!



>> Edited by nightdriver on Saturday 11th March 22:25

vixpy1

42,699 posts

295 months

Saturday 11th March 2006
quotequote all
Changeing the voltage on the MAF is a common trick, its used on Diesels alot.

In this case its probably just making the engine run a bit leaner, too lean and goodbye engine.

lockstock2sb

Original Poster:

2,855 posts

274 months

Saturday 11th March 2006
quotequote all
So he spent £3.49 on his resistor and then £100 on a rolling road session to verify his findings of a 12BHP increase ? i think not !! If he did he was a very silly boy

nightdriver

1,082 posts

257 months

Saturday 11th March 2006
quotequote all
vixpy1 said:
Changeing the voltage on the MAF is a common trick, its used on Diesels alot.

In this case its probably just making the engine run a bit leaner, too lean and goodbye engine.


I thought most of these ebay jobbies were to go onto the lambda sensor and change the reading of that. I always assumed it was to increase fueling/richen the misture......

wedg1e

27,046 posts

296 months

Saturday 11th March 2006
quotequote all
r5gttgaz said:




works a treat 0-60 down from 11.3 to 8.2 (fiat punto cabrio) A*
Buyer rachael19710 ( 27 )
23-Sep-05 19:04
7999780162


Well she's crap at launches then 'cos I can get me Julie's 1242cc Punto to 60 in less than 11.3...
Maybe she tried it twice, and second time put the roof up?

vixpy1

42,699 posts

295 months

Saturday 11th March 2006
quotequote all
nightdriver said:
vixpy1 said:
Changeing the voltage on the MAF is a common trick, its used on Diesels alot.

In this case its probably just making the engine run a bit leaner, too lean and goodbye engine.


I thought most of these ebay jobbies were to go onto the lambda sensor and change the reading of that. I always assumed it was to increase fueling/richen the misture......


Most Lambdas only work when the car is idleing/ light throttle.. So altering the signal from that would make no difference

vixpy1

42,699 posts

295 months

Saturday 11th March 2006
quotequote all
Right guys need a n/a shitty old car..

Gonna buy one of these and have some fun on the dyno

nightdriver

1,082 posts

257 months

Saturday 11th March 2006
quotequote all
vixpy1 said:
nightdriver said:
vixpy1 said:
Changeing the voltage on the MAF is a common trick, its used on Diesels alot.

In this case its probably just making the engine run a bit leaner, too lean and goodbye engine.


I thought most of these ebay jobbies were to go onto the lambda sensor and change the reading of that. I always assumed it was to increase fueling/richen the misture......


Most Lambdas only work when the car is idleing/ light throttle.. So altering the signal from that would make no difference


Oh Right, so it changes the voltage from on the MAF. But why would you want to run leaner to increase power, would it not make the ECU 'see' a higher air flow than there really is so it would increase fueling making it richer.

Sorry for all the q's, I'm genuinely interested!

Cheers

vixpy1

42,699 posts

295 months

Saturday 11th March 2006
quotequote all
nightdriver said:
vixpy1 said:
nightdriver said:
vixpy1 said:
Changeing the voltage on the MAF is a common trick, its used on Diesels alot.

In this case its probably just making the engine run a bit leaner, too lean and goodbye engine.


I thought most of these ebay jobbies were to go onto the lambda sensor and change the reading of that. I always assumed it was to increase fueling/richen the misture......


Most Lambdas only work when the car is idleing/ light throttle.. So altering the signal from that would make no difference


Oh Right, so it changes the voltage from on the MAF. But why would you want to run leaner to increase power, would it not make the ECU 'see' a higher air flow than there really is so it would increase fueling making it richer.

Sorry for all the q's, I'm genuinely interested!

Cheers


Running a car richer will not make more power. You are essentially looking for an ideal combustion. If there is too much fuel you do not get this, so leaning the mixture out from manufactuers standards might get you a few more hp. However, the leaner you go the more chance of detonation and goodbye engine, hence the manufactuers run the cars a bit rich. Some ECU's will advance the timing as they run leaner, not sure ford mondeo's do though

Its probably detting its tits off running 14:1 AF Ratio!

What you suggest does however work on diesel cars. Its how most of these tuning boxs work too be honest


>> Edited by vixpy1 on Saturday 11th March 22:39

vixpy1

42,699 posts

295 months

Saturday 11th March 2006
quotequote all
Gazboy said:
vixpy1 said:
Right guys need a n/a shitty old car..

Gonna buy one of these and have some fun on the dyno


Would your TVR suffice?


There's always one smart arse

monkeyhanger

9,268 posts

273 months

Saturday 11th March 2006
quotequote all
"and for me, it outperformed a £250 *****chip"

Now that is the only believable part of the ad

nightdriver

1,082 posts

257 months

Saturday 11th March 2006
quotequote all
vixpy1 said:
nightdriver said:
vixpy1 said:
nightdriver said:
vixpy1 said:
Changeing the voltage on the MAF is a common trick, its used on Diesels alot.

In this case its probably just making the engine run a bit leaner, too lean and goodbye engine.


I thought most of these ebay jobbies were to go onto the lambda sensor and change the reading of that. I always assumed it was to increase fueling/richen the misture......


Most Lambdas only work when the car is idleing/ light throttle.. So altering the signal from that would make no difference


Oh Right, so it changes the voltage from on the MAF. But why would you want to run leaner to increase power, would it not make the ECU 'see' a higher air flow than there really is so it would increase fueling making it richer.

Sorry for all the q's, I'm genuinely interested!

Cheers


Running a car richer will not make more power. You are essentially looking for an ideal combustion. If there is too much fuel you do not get this, so leaning the mixture out from manufactuers standards might get you a few more hp. However, the leaner you go the more chance of detonation and goodbye engine, hence the manufactuers run the cars a bit rich. Some ECU's will advance the timing as they run leaner, not sure ford mondeo's do though

Its probably detting its tits off running 14:1 AF Ratio!





Ah, I see. I always thought (assumed) that most road cars would (as standard) have an AF ratio of as close to 14.7:1 as possible or maybe even up to 15.4:1 (being where best fuel economy is normally seen?!?). And I have been told that max power is usually seen at an AF of 12.6:1.... Or have I been told some porkies!

PS. I was working at the Longcross stages the other week, just by your rolling road!

>> Edited by nightdriver on Saturday 11th March 22:46

Polarbert

17,936 posts

262 months

Saturday 11th March 2006
quotequote all
Can't believe that nobody has posted the picture yet. It says it all really.

vixpy1

42,699 posts

295 months

Saturday 11th March 2006
quotequote all
monkeyhanger said:
"and for me, it outperformed a £250 *****chip"

Now that is the only believable part of the ad


I can't say it publically.. but you have no idea what i can't actually say.. if ya get me

>> Edited by vixpy1 on Saturday 11th March 23:13

vixpy1

42,699 posts

295 months

Saturday 11th March 2006
quotequote all
nightdriver said:
Ah, I see. I always thought (assumed) that most road cars would (as standard) have an AF ratio of as close to 14.7:1 as possible or maybe even up to 15.4:1 (being where best fuel economy is normally seen?!?). And I have been told that max power is usually seen at an AF of 12.6:1.... Or have I been told some porkies!

PS. I was working at the Longcross stages the other week, just by your rolling road!

>> Edited by nightdriver on Saturday 11th March 22:46


14.7 is ideal, but in reality on full bore runs a car will go pop because the mixture will pre ignite.

On cruise then AFR's like that are quite doable, but on full throttle you look for 13:1 on N/A's and 11 to 12:1 for Turbos.

However, many turbo cars run much richer as standard.. it depends on the engine too be honest. Honda Vtecs can be run much much leaner than Rover V8's for instance

Ahh.. you saw the sign then. I was wandering around and in the one of the people running its car most of the day.

>> Edited by vixpy1 on Saturday 11th March 23:12

m1spw

5,999 posts

256 months

Saturday 11th March 2006
quotequote all
Polarbert said:
Can't believe that nobody has posted the picture yet. It says it all really.


I don't see why he didn't make the number plate read "3BAY", or "E8AY", or something that would be a proper legal nuberplate. Shows how much he really knows about cars!

Also, look at the feedback for his item, and click to see the feedback that the first guy got. Interesting...

>> Edited by m1spw on Saturday 11th March 23:16