Stud/Bush holder

[Slow M]

PM me if you would like a copy of the CAD file. (.dwg)2004
B

(Revised Dec. 3 2009)

Edited by Slow M on Thursday 3rd December 17:28

[Slow M]

Adrian,
If you like, send me a sketch showing the dimensions of the early version and I'll be happy to draw that up too.
B.

[Slow M]

Adrian@ said:

Simple really... the internal bore of the eyelet has a full 1 inch and then minor chamfer to outside edge (IF you try fitting a current rubber bush into the early eyelet the rubber tries to rip off the sleeve ..hence the requirement to dress the centre-line of the rubber bush so as to relieve the pressure) Adrian@
P.S. when I say current bush ...these have been as this from around 1974, and the hence the conversion to the later eyelet.

Like this?
B