TVR V8S Rebuild
Discussion
gifdy said:
My front steel plate wasn't up to the job unfortunately. Need to try again or get it laser/waterjet cut in order to get the alignment
In the meantime I tried a carbon fibre plate. This is the back plate so I didn't pay much attention to the finish. However, it came out pretty well. I really like this so at the moment I'm thinking to go this route. I may change my mind tomorrow
Be very careful cutting carbon fibre the fibres released are nasty stuff if you get it in your lungs .In the meantime I tried a carbon fibre plate. This is the back plate so I didn't pay much attention to the finish. However, it came out pretty well. I really like this so at the moment I'm thinking to go this route. I may change my mind tomorrow
gifdy said:
The Jolly Todger said:
Re. The whining noise.
Could it simply be an over-tightened belt? I over-tensioned the alternator belt on my old Golf and it whined like it had a super charger, slackened it off and the problem was gone. It will almost certainly be that or some other bearing problem with something driven off the ancillary belt. You could always take it off an run it without for a few seconds to confirm.
I'll give that a go - thanks !Could it simply be an over-tightened belt? I over-tensioned the alternator belt on my old Golf and it whined like it had a super charger, slackened it off and the problem was gone. It will almost certainly be that or some other bearing problem with something driven off the ancillary belt. You could always take it off an run it without for a few seconds to confirm.
Finally got the interior finished. The heater panel needs a tweak but I'm pretty happy with it. Just need to get the engine tuned and then it's MOT time !
Notice the scratch on the front. We had some high winds that blew the garage door off it's hinges and it whacked into the front of the car. I was furious. I closed the door and couldn't go in the garage for two weeks !
The clock on the far left is still the old style until I can locate a voltage gauge in the same style
Heater panel needs to drop in a bit tighter but otherwise it's looking good
New harnesses
Notice the scratch on the front. We had some high winds that blew the garage door off it's hinges and it whacked into the front of the car. I was furious. I closed the door and couldn't go in the garage for two weeks !
The clock on the far left is still the old style until I can locate a voltage gauge in the same style
Heater panel needs to drop in a bit tighter but otherwise it's looking good
New harnesses
What are you waiting for ?
This is a nice one - http://www.pistonheads.com/sales/4081299.htm
and if you want a stupidly fast one - http://www.pistonheads.com/sales/3961562.htm
This is a nice one - http://www.pistonheads.com/sales/4081299.htm
and if you want a stupidly fast one - http://www.pistonheads.com/sales/3961562.htm
Gassing Station | Readers' Cars | Top of Page | What's New | My Stuff