Emerald Triple Map Switch ?

[rev-erend]

Hi - has anyone fitted the Emerald Triple Map Switch ?

I was kind of expection the usual rear of the switch to have 3 flat blade connectors but it has an outer ring of smaller connectors (about 12) and an inner ring of 4 small connectors.

There is also a 1 ohn resistor - which page 40 of the manual shows as going to earth but is it soldered along side the cable (parallel) of in series - as it shown in the manual..

[rev-erend]

trackcar said:

other serial connector.

Thanks - what's the other connector ?

[rev-erend]

CNHSS1 said:

if you get no joy, drop me a line and i will photograph my setup and the wiring.

OK - Thanks..

Question is with Emerald.. Leooni says it gets asked plenty of times..