Dizzy wiring RV8
Discussion
Tried this on the Wedge forum, but no takers.
Having a few probs with my wasted spark + MS setup, so I was going to give it a try with the old dizzy and coil setup. Unfortunately I foolishly removed the wires from the module, on the side of the dizzy, without marking where they went. Can anyone enlighten me?
Also the wire from this module that would have sent a signal to the ECU?? Any suggestions, as the ECU is now triggerd from the VR sensor on the crank pulley? Should I earth this wire or just leave it disconnected? It's white and black for your info.
Cheers in anticipation.
Having a few probs with my wasted spark + MS setup, so I was going to give it a try with the old dizzy and coil setup. Unfortunately I foolishly removed the wires from the module, on the side of the dizzy, without marking where they went. Can anyone enlighten me?
Also the wire from this module that would have sent a signal to the ECU?? Any suggestions, as the ECU is now triggerd from the VR sensor on the crank pulley? Should I earth this wire or just leave it disconnected? It's white and black for your info.
Cheers in anticipation.
I never managed to issolate a misfire on wasted spark and wanted to run the dizzy + coil again to see if it makes any difference.
The coil wiring is no probs, but I took the wires off the module on the side of the dizzy and forgot to mark them and there are no marks to suggest which way they would go on. There are only two terminals on this module.
I've actually sent the MS back to my supplier so that it can be converted to run EDIS 8. Hopefully back next week.
The coil wiring is no probs, but I took the wires off the module on the side of the dizzy and forgot to mark them and there are no marks to suggest which way they would go on. There are only two terminals on this module.
I've actually sent the MS back to my supplier so that it can be converted to run EDIS 8. Hopefully back next week.
Gassing Station | Engines & Drivetrain | Top of Page | What's New | My Stuff