LS9 heads on to LS2 block?
Discussion
MyM8V8 said:
http://www.jegs.com/i/Chevrolet+Performance/809/19...
These are the ones which Gurmeet pointed me in the direction of. Only issue for me is the limited lift of .570 with the fitted beehive springs.
Titanium valves and CNC for $890 a piece. What's the catch???
They seem like a bargain, jegs did sell stock ls3 heads very cheap over christmas These are the ones which Gurmeet pointed me in the direction of. Only issue for me is the limited lift of .570 with the fitted beehive springs.
Titanium valves and CNC for $890 a piece. What's the catch???
Just swap the spring for a decent set of beehives for insurance
MyM8V8 said:
http://www.jegs.com/i/Chevrolet+Performance/809/19...
These are the ones which Gurmeet pointed me in the direction of. Only issue for me is the limited lift of .570 with the fitted beehive springs.
Titanium valves and CNC for $890 a piece. What's the catch???
They do look good very good. Perhaps they were ported by LS8VPower ? These are the ones which Gurmeet pointed me in the direction of. Only issue for me is the limited lift of .570 with the fitted beehive springs.
Titanium valves and CNC for $890 a piece. What's the catch???
Anyway, I can vouch for these and they're not massively expensive: http://www.lingenfelter.com/mm5/merchant.mvc?Scree...
Only other thing to note is those heads use sodium filled exhaust valves instead of inconel which deal with the heat better. Wonder how it can be alright to use 11mm studs in a 12mm hole, do you just do them up "really tight" and hope they don't move?
wormus said:
They do look good very good. Perhaps they were ported by LS8VPower ?
Anyway, I can vouch for these and they're not massively expensive: http://www.lingenfelter.com/mm5/merchant.mvc?Scree...
Only other thing to note is those heads use sodium filled exhaust valves instead of inconel which deal with the heat better. Wonder how it can be alright to use 11mm studs in a 12mm hole, do you just do them up "really tight" and hope they don't move?
They can't move because the heads are dowel located to the block. The bolts apply a vertical clamping force.Anyway, I can vouch for these and they're not massively expensive: http://www.lingenfelter.com/mm5/merchant.mvc?Scree...
Only other thing to note is those heads use sodium filled exhaust valves instead of inconel which deal with the heat better. Wonder how it can be alright to use 11mm studs in a 12mm hole, do you just do them up "really tight" and hope they don't move?
Gassing Station | HSV & Monaro | Top of Page | What's New | My Stuff