Voltage reading on display
Discussion
Wonder if anyone can shed any light..
Have a slight musty & hot smell in the cabin when car has warmed up. Checked the carpets - nope, checked if it is blowing in from vents - nope.
Has coincided with me noticing that the voltage reading on the selectable display is fluctuating rapidly between 12.1v and 12.8v
Any thoughts whether these are connected?
If not is the reading low anyway? Battery or fused link under air-box?
Crumbs! I always seem to bring along the nuggety little ones
Have a slight musty & hot smell in the cabin when car has warmed up. Checked the carpets - nope, checked if it is blowing in from vents - nope.
Has coincided with me noticing that the voltage reading on the selectable display is fluctuating rapidly between 12.1v and 12.8v
Any thoughts whether these are connected?
If not is the reading low anyway? Battery or fused link under air-box?
Crumbs! I always seem to bring along the nuggety little ones

Jez, The 100Amp altermator fuse under the airbox can cause this if its not tightened fully and then it starts to heatup and will fail.
if the tams same as the sagaris the main fuse is in the passenger footwell this could be hot musty smell the car has ??
Can also cause ECU to stutter
if the tams same as the sagaris the main fuse is in the passenger footwell this could be hot musty smell the car has ??
Can also cause ECU to stutter
Edited by VARLEYHYD on Tuesday 3rd April 09:58
Thanks Graham
Finally got to the bottom of it on Sunday
The Tam Fuse holder is similar to the one there - mounted differently
Basically the fuse had partially fractured and providing much much resistance/arc - causing cable to overheat on one side, melting fuse holder partially and darkening insulation. Clues were smell, low voltage on pod and stuttering at 6K RPM (not enough juice for ignition?)
Replaced fuse, holder, locking nuts etc (big thanks to Clevor Trevor) - hey presto - very quick, non smelly Tam again. Also been advised that the fuse should be 100amp, not the 80amp
Hope this helps someone else - judging by the melted fuse holder - it could have been worse
Coach
Finally got to the bottom of it on Sunday
The Tam Fuse holder is similar to the one there - mounted differently
Basically the fuse had partially fractured and providing much much resistance/arc - causing cable to overheat on one side, melting fuse holder partially and darkening insulation. Clues were smell, low voltage on pod and stuttering at 6K RPM (not enough juice for ignition?)
Replaced fuse, holder, locking nuts etc (big thanks to Clevor Trevor) - hey presto - very quick, non smelly Tam again. Also been advised that the fuse should be 100amp, not the 80amp
Hope this helps someone else - judging by the melted fuse holder - it could have been worse
Coach

coach said:
Thanks Graham
Finally got to the bottom of it on Sunday
The Tam Fuse holder is similar to the one there - mounted differently
Basically the fuse had partially fractured and providing much much resistance/arc - causing cable to overheat on one side, melting fuse holder partially and darkening insulation. Clues were smell, low voltage on pod and stuttering at 6K RPM (not enough juice for ignition?)
Replaced fuse, holder, locking nuts etc (big thanks to Clevor Trevor) - hey presto - very quick, non smelly Tam again. Also been advised that the fuse should be 100amp, not the 80amp
Hope this helps someone else - judging by the melted fuse holder - it could have been worse
Coach
Finally got to the bottom of it on Sunday
The Tam Fuse holder is similar to the one there - mounted differently
Basically the fuse had partially fractured and providing much much resistance/arc - causing cable to overheat on one side, melting fuse holder partially and darkening insulation. Clues were smell, low voltage on pod and stuttering at 6K RPM (not enough juice for ignition?)
Replaced fuse, holder, locking nuts etc (big thanks to Clevor Trevor) - hey presto - very quick, non smelly Tam again. Also been advised that the fuse should be 100amp, not the 80amp
Hope this helps someone else - judging by the melted fuse holder - it could have been worse
Coach

Phew, that was close. Mrs Bert's Galaxy set itself on fire when one of the fusible links did this.
Bert
i go offshore now and again for a week or two, once for three and in jan/feb my car sat for 6 weeks while i was er, cough banned/offshore.
Other than that it doesnt sit any longer than 2 days without being used, i havent got one of those trickle chargers either, touch wood its always started first time.
Other than that it doesnt sit any longer than 2 days without being used, i havent got one of those trickle chargers either, touch wood its always started first time.
Gassing Station | Tamora, T350 & Sagaris | Top of Page | What's New | My Stuff






