alarm gone mad
Discussion
..its a little back box about 4" by 2" with Meta written on it under the centre console. And for the uninitiated the central section of the centre console is removed before the arm rests as they are two separate pieces (undo the screw under the "floor" of the small rear cubby hole of the central panel to start off)
Been talking to AVS of Bath (has anyone heard of them/any good or bad experiences) and they say it's because i've got the microphone sensors not microwave sensors and the noise of the soft top is causing the alarm to trigger.
It will cost about £110 upwards (inc callout...) to convert.
This sounds plausable to me, and doesn't seem to cost too much to fix (but then what do I know?!?). What does everyone else think?
It will cost about £110 upwards (inc callout...) to convert.
This sounds plausable to me, and doesn't seem to cost too much to fix (but then what do I know?!?). What does everyone else think?
Talk to Karl Baker (www.tvruk.tv) - the man for Alarms in TVRs.
If it's a Foxguard system, you might find it's the siren unit itself in front of the rad that's got water in it.
Brilliant place to put the siren: it's susceptible to moisture, and it's situated at the very front of the car where a ram affect ensures that water gets well and truly forced into it.
Brilliant place to put the siren: it's susceptible to moisture, and it's situated at the very front of the car where a ram affect ensures that water gets well and truly forced into it.

Gassing Station | Chimaera | Top of Page | What's New | My Stuff




