Range Rover classic

[dunk7]

Also fitted a set of Tuff-Rock mud flaps

[dunk7]

DonkeyApple said:

Does look nicer with the tyres in line with the body work.

Cheers yes i think so and being a tarmac queen no issues with catching the body work, i shall do a few miles then pop the wheels off and inspect the spacers to make sure they are up to the job.

[dunk7]

At Twenty Ten Engineering on the lowest suspension setting

[dunk7]

EAS has packed up, its now sat on the bump stops.

Got a new compressor relay coming along with the delay relay, also bought a spare EAS ecu from a softdash being broken locally

[dunk7]

A tad low

[dunk7]

Changed the compressor relay no change, changed the delay relay no change, also changed the warning change over relay and nothing.
Going to check the 60A link fuse that i've just discovered in the engine bay fuse box

Time to get it plugged in and see what faults are stored

Edited by dunk7 on Friday 4th December 14:12

[dunk7]

Cheers for the replies guys.

The 60A link fuse was fine, plugged into the system using the Lynx diagnostics
and it flagged up some very different numbers on the height sensors.

3 of them weren't that far apart and in the 70's where as the osf was 280.

I bought a spare set ages ago so changed the osf and its working as it should. Cleared the fault codes and none re appeared so happy days.

Going to overhaul the valve block, dryer and compressor then look at replacing all the height sensors for new P38 version which i'm told with fit with a wiring mod

[dunk7]

Anyone know of a wiring diagram for the SRS system.

Mines flagged up a fault with a resistor short

[dunk7]

Or know of an SRS specialist

[dunk7]

https://www.rangerovers.net/threads/abs-brake-modu...

[dunk7]

Since Phil at Twenty Ten engineering cleared the SRS fault the warning light
has gone off as it should.

Heated screen worked nicely the other day and from frozen solid it was clear after 3 mins

[dunk7]

[dunk7]

Will be fitting new EAS height sensors along with a new dryer and bump stops as soon as i can get it on a ramp

[dunk7]

[dunk7]

[dunk7]

[dunk7]

[dunk7]

NomduJour said:

Where are those from?

What are you referring too ?

[dunk7]

NomduJour said:

Sorry, quote fail - the height sensors.

Best deal outside of ebay that I found was LR Direct

https://www.lrdirect.com/home.php

These are the part numbers

STC3733AA RH FRONT GREEN DUNLOP
STC3734AA LH FRONT RED DUNLOP
STC3735AA RH REAR GREEN DUNLOP
STC3736AA LH REAR RED DUNLOP

[dunk7]

Cat pipe fitted along with my custom bump stops and height sensors, also bought a NOS LHD wiper mechanism which i shall turn into a RHD