Carbon Fibre Dash

[Davrianman]

Just bought one of these from Carbon Mods...



Here is the link: http://www.carbonmods.co.uk/showProduct.asp?prodID...

It should fit well hopefully, and at £80, it's a lot cheaper than most plain carbon sheet I was quoted.

I will probably cut off the lip at the bottom of the dash and most of the dash face to fit this. When removed it will give good access to cabling etc... I'm going to have more carbonfibre than Airbus in my garage soon! :-)

Cheers,

Mart

[ezakimak]

The carbon canards and front splitter look nice, might be pushing it a bit with the 1600mm width. Maybe they could do a wider one if asked. I wonder if the front edge is wrapped under the rubber seal?

[CanAm Dave]

Hi Mart

I've been looking at that panel myself. What is the quality like?

Regards Dave

[Davrianman]

Hi Dave,

Not arrived yet. Should be here next week, so will let you know...

Mart

[Davrianman]

ezakimak said:

The carbon canards and front splitter look nice, might be pushing it a bit with the 1600mm width. Maybe they could do a wider one if asked. I wonder if the front edge is wrapped under the rubber seal?

Just measured the front clip as was thinking the same thing... You will probably need 1900mm width, although the largest depth plate is fine. I am going to ask if they go a longer version...