Pectel T2 datalog software

[catsv7]

I am looking for Pectel T2 Datalog software or equivalent. Does anyone know where I might be able locate a copy of Datalog?

I am located in the USA and have 2002 build Caterham SV which I purchase in 2016. The car came with zero documentation. I have been making Datalog enquiries on other forums in the USA but have not received a response so far.

TIA
Greg

[gregpe]

HI T2 is an old device but for data analysis you would need "Toolbox" and for offloading data "Pectel OFFload tool" software. To make changes at ecu you need DescPro with correct profile

[catsv7]

Hi gregpe,

Fortunately I have DescProw. I tried previously downloading the "Pectel OFFload tool" from the Cosworth site. It would not install correctly. Cosworth sent me another file which seemingly installed correctly. However, upon launching the software would prompt me to reset the ecu. I reported the behaviour to Cosworth and I am waiting upon a response. So I continue to hunt for the old datalog software.

[gregpe]

toolbox should work with it? Reset ecu it means power-cycling..normally used for programming mode..

[catsv7]

gregpe thanks for your response


As noted in your previous message "Toolbox" is for data analysis (after using data off load). When I launch "Pectel OFFload tool" it gives me the only option of "reset" or programming mode (per your previous message). Do I have to go through the programming mode to retreive data?