Rear fog switch S3
Discussion
Hello
Need to check why rear fogs not working.. looks like switch may come out forward without removing centre console but I don't want to break it.. so will the switches come out without removing console or not folks.?
Is there a technique so I don't break tabs etc.?
Many thanks
Damian S3
Need to check why rear fogs not working.. looks like switch may come out forward without removing centre console but I don't want to break it.. so will the switches come out without removing console or not folks.?
Is there a technique so I don't break tabs etc.?
Many thanks
Damian S3
They will wiggle forward fairly easy from the panel, but may be tricky if the veneer is still in front. There is a risk though that you'll disconnect all the wies form the switch in the process.
Much better to lift the centre console. Just twp screws under the caps at the rear and gear knob off, then you can lift the console up.
Much better to lift the centre console. Just twp screws under the caps at the rear and gear knob off, then you can lift the console up.
RayTVR said:
They will wiggle forward fairly easy from the panel, but may be tricky if the veneer is still in front. There is a risk though that you'll disconnect all the wies form the switch in the process.
Much better to lift the centre console. Just twp screws under the caps at the rear and gear knob off, then you can lift the console up.
Yup reckon you are right.. small job for tomorrow evening then.. Much better to lift the centre console. Just twp screws under the caps at the rear and gear knob off, then you can lift the console up.
Cheers
Damian S3
Scoobimax said:
DamianS3 said:
small job for tomorrow evening then..
Cheers
Damian S3
Dangerous planning assumption Cheers
Damian S3
Ok on with this.. tried to pull switch forward ... mistake.. just pulled the plug off the back anyways aside from the horror wiring left by the last couple of specialists to see the car..!!! more on this later.
But basically no tell tale bulb in switch .. must have been lost when apart ?
Been to a couple of motor factors with photo of plug and switch in hand but cant identify the bulb..
Any ideas guys would like to drop for MOT today if I can find one..?
Thanks as always
Damian
But basically no tell tale bulb in switch .. must have been lost when apart ?
Been to a couple of motor factors with photo of plug and switch in hand but cant identify the bulb..
Any ideas guys would like to drop for MOT today if I can find one..?
Thanks as always
Damian
Gassing Station | S Series | Top of Page | What's New | My Stuff