TVR Logo - Laser Cut Stainless Steel

[TVRees]

Recently has these "2 layer" TVR logos made locally.

The logo layout is from a self-made CAD file (.dxf file is available) and the cost was approx. £4 per individual piece.

The ones shown in the photo are 13 x 5 cm, and smaller will also be possible.

If anyone wants the .dxf or .sldprt (Solidworks) files, drop me a PersMail.

[Jerseyjohn]

This looks good, could you send me the file you used to adapt it to make a V6 plate please.

[TVRees]

No problem, send me an email and I'll send you the files.
Tim

[Jerseyjohn]

I will be sending on of these for Tim to get cut for me, if anyone is interested I am sure he help if you wanted one cut.

[Discopotatoes]

These look great, would you be interested in making something up?

[TVRees]

Getting some made would not be a problem. Is the "you" me or do you mean Jerseyjohn ?

[Discopotatoes]

TVRees said:

Getting some made would not be a problem. Is the "you" me or do you mean Jerseyjohn ?

I did mean you, I'm looking for a v8 plenum badge, but there are none that have 4.8 available off the shelf, and I can't use that cad thingy. I'm looking for something to match the style of these, but with the black backing like yours, if that makes sense?

[TVRees]

At the moment, I only have the CAD files for the logos shown in the first photos. These are approx. 50mm or alternatively, 40mm height.

What are the dimensions of the parts shown in the photos which you sent ?

Also, what did you mean by :

Discopotatoes said:

... but there are none that have 4.8 available off the shelf ...

[Alan Whitaker]

Many Thanks Tim

Alan

[Alan Whitaker]

Hi Tim, Do you still have these files

Alan

[TVRees]

Alan Whitaker said:

Hi Tim, Do you still have these files. Alan

Yes, I can send them again, if you send me your email address.
Check your email for a message from me.

[Alan Whitaker]

Hi Tim, I was wanting to know if you had done a TVR V8 logo as well as the V6,

Alan

[Barkychoc]

could I also have the files Tim? I'll PM you to send my address. Is it any pain to also send in PDF?

[TVRees]

It's not a problem to send these as .pdf files. At the moment, I just have the V6 as a CAD logo. I can also make a V8, but I am super busy at the moment, so this may take a few weeks as I'm still a novice with the CAD program.

[julian64]

Hi can I get a sldprt file of the TVR logo please. Have emailed you

[TVRees]

I'll be back home in a few days. I'll send everyone who asked, some copies of the files by the end of next week.

[v8s4me]

I'd be interested in a V8S one as well please.

[Tonymg]

TVRee do you have any cad files of any Chim Dash? 1998 pre or after 98 just need the shape top and bottom bits

[TVRees]

Sorry Tony, I'm an "S" owner and I only have some 3D CAD files for the TVR-S.

[Tonymg]

Ok alls well... thanks for getting back to me...