New coil fitted, MSD Blaster 2
Discussion
Well, with the plenum insulator its always been a bit good in 4th and 5th for general M Way pulling at low revs. Went for a test after fitting (service at DJE and he recomended it). Poked the throttle in 4th and there was a bigger go for it and the snarl was more pronounced. 60 to 80 is a dodle....er did I say 80, ment 70. Very smooth.
It was explained that the standard coil voltage was decreasing with respect to revs increasing. This one shoves out more volts so at higher revs so there is a better spark.
Had the chrome oil filter again, for the hell of it.
>> Edited by jmorgan on Thursday 17th June 23:34
It was explained that the standard coil voltage was decreasing with respect to revs increasing. This one shoves out more volts so at higher revs so there is a better spark.
Had the chrome oil filter again, for the hell of it.
>> Edited by jmorgan on Thursday 17th June 23:34
DJE Nuneaton. I am not on comisssion by the way.
DJE Link
Also I understand he has tested on a dyno rather than rely on sales blurb.
Also check the price first, sure I have quoted the correct price but done,t quote me. Too many quotes there
>> Edited by jmorgan on Friday 18th June 13:20
DJE Link
Also I understand he has tested on a dyno rather than rely on sales blurb.
Also check the price first, sure I have quoted the correct price but done,t quote me. Too many quotes there
>> Edited by jmorgan on Friday 18th June 13:20
Gassing Station | Wedges | Top of Page | What's New | My Stuff