Throttle pot sensor required please
Discussion
Hi guys
Dont post very often and i need some help
My 450 flapper cut out today and upon investigation i found the yellow wire had gone brittle and broke
Rubbing on plenum .
Can anybody help with with a good second hand one for dosh, beer or whatever.
I have checked with rimmers there 100 squid? Obviously a last resort.
I would like to know if anybody has a good spare.
Thanks
Greg
Dont post very often and i need some help
My 450 flapper cut out today and upon investigation i found the yellow wire had gone brittle and broke
Rubbing on plenum .
Can anybody help with with a good second hand one for dosh, beer or whatever.
I have checked with rimmers there 100 squid? Obviously a last resort.
I would like to know if anybody has a good spare.
Thanks
Greg
Edited by celcius on Wednesday 23 April 17:01
Hi guys
Many thanks for you swift answers.
I will hunt a spare down sometime.
The repair looks ok so will test it when it stops raining
The voltages are all spot on so should be ok.
Thanks keith but its the later one
Ian i owe you a beer .
Just out of curiosity when the pot is disconnected i know the car runs fine but does it go on limp mode so to speak .
Does the ecu just read from AFM?
Greg
Many thanks for you swift answers.
I will hunt a spare down sometime.
The repair looks ok so will test it when it stops raining
The voltages are all spot on so should be ok.
Thanks keith but its the later one
Ian i owe you a beer .
Just out of curiosity when the pot is disconnected i know the car runs fine but does it go on limp mode so to speak .
Does the ecu just read from AFM?
Greg
Yeah the AFM will meter the air and give some fuelling but the enrichment from the throttle pot opening won't happen. I suppose it will be quite down on power and there won't be a squirt of fuel to get it going when you floor it, it will gradually pick up because of the AFM opening as the revs rise.
Gassing Station | Wedges | Top of Page | What's New | My Stuff