The other headlamp!!!!!!! Grrrr

The other headlamp!!!!!!! Grrrr

Author
Discussion

TVRIK

Original Poster:

892 posts

157 months

Tuesday 2nd September 2014
quotequote all
So if finally got round to sorting the motor on the passenger headlamp, and it's a success!!
Works beautifully... Thanks again Marcus for the part you sent me!

However the other one has completely stopped working, nothing!
This happens before I started on the other mind, it was stuck up but I put it down to the battery being low, just assumed it would work fine once charged!

Any ideas??? On this I've checked the fuse I believe it to be and that's fine.

Rik

jindle

246 posts

125 months

Tuesday 2nd September 2014
quotequote all
Have you tried wiggling the wiring from underneath? Otherwise: relay, usual wiring stuff...

marcus1875

1,512 posts

142 months

Tuesday 2nd September 2014
quotequote all
Swap them around to check the motor actually works maybe? I've another two in various stages of disrepair, no fully functioning though if you need any spares.
although i have another one at a sparks for reconditioning, it that works and comes in at a decent price them i'll ask him to do the other three which will then be available to chums.
marcus

TVRIK

Original Poster:

892 posts

157 months

Tuesday 2nd September 2014
quotequote all
Nice one Marcus.. I'm thinkin it must be the relay or fuse,
As it wen from working perfect to nothing not even a sound.
The light is on when ya look down the gap.

I took both relays out that According to the bible was the light motors, but the other still worked!!
So I'm guessing that's wrong, I did notice one if the relays was quite hot!

Maybe that's the one'! Ah the joys!

Thanks again pal, and for the nylon gear, that's worked a treat!

Rik

jindle

246 posts

125 months

Tuesday 2nd September 2014
quotequote all
If your relay panel is a row of 5, a row of 5 then a row of 7. Then from top row the second relay is pod control, with left pod relay below it, and right pod relay below that

TVRIK

Original Poster:

892 posts

157 months

Tuesday 2nd September 2014
quotequote all
jindle said:
If your relay panel is a row of 5, a row of 5 then a row of 7. Then from top row the second relay is pod control, with left pod relay below it, and right pod relay below that
I'll check that tomorrow, if I can find em, and I switch em, and they swap with regards to working, I've cracked it!

Cheers pal

Rik