Alternator adjuster - anyone tried these?
Discussion
adam quantrill said:
That seems roughly compatible. Is there a mark (or a lack of dirt) on the bar where the alternator bolt usually sits at the top? If you measure from that down to the bottom hole that will give a better confirmation.
I can cut the adjuster bar to suit the middle of the range needed.
Soz, only just got round to checking this....looking at a pre strip down picture it would appear the adjuster bolt was around 25-30mm from the very top of the adjustment so it would put it around 250mm bolt to bolt. If that is ok then I will get a paypal payment to you straight away.I can cut the adjuster bar to suit the middle of the range needed.
Many thanks, John
Hi Stewart, many apologies what I thought was one in stock turned out to be gone.
However I have all the parts in and enough hex bar to make 2 up right away, so let me know if that's OK.
John, I just measured mine and it's the same, 250mm bolt-bolt, I must have misremembered (or maybe I was remembering the length of the bar not the overall length.) Let me know if you're still interested.
However I have all the parts in and enough hex bar to make 2 up right away, so let me know if that's OK.
John, I just measured mine and it's the same, 250mm bolt-bolt, I must have misremembered (or maybe I was remembering the length of the bar not the overall length.) Let me know if you're still interested.
Gassing Station | Wedges | Top of Page | What's New | My Stuff