Random TVR pics

[QBee]

Rainsport 3s on the front in case of bad weather?

[AutoAndy]

[AceOfHearts]

Sardonicus said:

AceOfHearts said:

Getting there then Lewis?

Slowly but surely. Been busy with the Sprite, Trabant and Land Rover so am currently time and money poor

[macdeb]

AceOfHearts said:

Sardonicus said:

AceOfHearts said:

Getting there then Lewis?

Slowly but surely. Been busy with the Sprite, Trabant and Land Rover so am currently time and money poor

Looks good, how come the offset to one side?

[BuzzBillsberry]

i

Cats off after I fitted new clutch




....and new slave

[AceOfHearts]

macdeb said:

AceOfHearts said:

Sardonicus said:

AceOfHearts said:

Getting there then Lewis?

Slowly but surely. Been busy with the Sprite, Trabant and Land Rover so am currently time and money poor

Looks good, how come the offset to one side?

Did the sums and my turbo seems quite a bit bigger than the kit supplied ones (HX35). Basically I had to get the turbo in place in the engine bay and build the manifold around it!

Hopefully next week I will be mocking it back up into the bay and getting the waste gate pipework sorted.

[RikJonAtk]

Cleaned the cars before I get married tomorrow.

[crmcatee]

Good luck for tomorrow.



This time last week the hills were alive with the sound of straight six.

[Dimension]

Sleeping before the the Jim Clark Revival at the Hockenheimring

[ukkid35]

crmcatee said:

Good luck for tomorrow.
This time last week the hills were alive with the sound of straight six.

That is very cool.

[aide]

ukkid35 said:

crmcatee said:

Good luck for tomorrow.
This time last week the hills were alive with the sound of straight six.

That is very cool.

+1
I wonder if that could be made into a poster with the caption on it?

[Matthew Poxon]

RikJonAtk said:

Cleaned the cars before I get married tomorrow.

Congratulations!

[pacato]

Make some noise!
(It sounds just a little louder - but much more aggressive...)

[fullpull]

pacato said:

Make some noise!
(It sounds just a little louder - but much more aggressive...)

Looks cool. What about the torque?

[pacato]

fullpull said:

Looks cool. What about the torque?

To work in the engine bay is much easier, too. Can´t say any negative about torque due to hot air: We took out the cats same time, car runs better now.

[Pootus]

pacato said:

Make some noise!
(It sounds just a little louder - but much more aggressive...)

Looks Great!

Did you have to re-map the ECU? What make are the filters and was it an easy fit?

[AutoAndy]

crmcatee said:

This time last week the hills were alive with the sound of straight six.

and filled with the odd V8 and loads of V6's...

[pacato]

Pootus said:

Looks Great!

Did you have to re-map the ECU? What make are the filters and was it an easy fit?

Thx!
No remapping until now.
It is the K&N Ru-1750.
At last it was not too bad to fix it. The angle is a little too small to fit in a Sagaris engine bay, so it must be cut with a high speed saw. After that it is extreme easy fit.

[macdeb]

[Andrew Gray]