Braking Distances - Which car determined the 'standard'?

Braking Distances - Which car determined the 'standard'?

Author
Discussion

XplusYplusZ

Original Poster:

241 posts

141 months

Sunday 29th September 2013
quotequote all
It's commonly said that todays cars easily out-perform the highway code stopping distances. So I was just wondering if anybody here knows how the braking distances in the Highway Code were established - which car(s)? I'm assuming they were 60s / 70s without power assistance and before ABS..

vonhosen

40,233 posts

217 months

Monday 30th September 2013
quotequote all
It would be useless knowing the car unless you knew a host of other conditions, so it's to a simple formula.

Reaction time 0.67 secs
Braking effort 0.67g

The reaction time is mostly optimistic, the braking mostly pessimistic for a good condition modern car on a dry road (but not so for a wet road).

HustleRussell

24,691 posts

160 months

Monday 30th September 2013
quotequote all
I've heard the stopping distances were based on a Ford Anglia, but almost certainly wrong!

XplusYplusZ

Original Poster:

241 posts

141 months

Monday 30th September 2013
quotequote all
Vanhosen, a good point. So how did they come to a .67g constant?

Engineer1

10,486 posts

209 months

Monday 30th September 2013
quotequote all
Isn't it proven in most accidents people didn't brake as hard as the vehicle's maximum would allow.

Munter

31,319 posts

241 months

Monday 30th September 2013
quotequote all
Engineer1 said:
Isn't it proven in most accidents people didn't brake as hard as the vehicle's maximum would allow.
That's why Merc came up with Emergency Brake Assist (or Distribution?). People brake faster and harder than they normally do. But they normally tickle the brake. So there is still plenty of brake capacity left. Then when it's clearly too late they push hard enough to kick the ABS in. EBA just notices stage one of that and throws everything it has at stopping the car before the "it's too late" stage comes about.

andy_s

19,400 posts

259 months

Monday 30th September 2013
quotequote all
Munter said:
Engineer1 said:
Isn't it proven in most accidents people didn't brake as hard as the vehicle's maximum would allow.
That's why Merc came up with Emergency Brake Assist (or Distribution?). People brake faster and harder than they normally do. But they normally tickle the brake. So there is still plenty of brake capacity left. Then when it's clearly too late they push hard enough to kick the ABS in. EBA just notices stage one of that and throws everything it has at stopping the car before the "it's too late" stage comes about.
That's reassuring. Who can't press a brake pedal?

Engineer1

10,486 posts

209 months

Monday 30th September 2013
quotequote all
It's not who can't press a pedal more people panic find their seat position is such that they can't push it to the floor or just fear the feeling of lack of control when the total available braking force is applied.

RDR 838

94 posts

136 months

Monday 30th September 2013
quotequote all
HustleRussell said:
I've heard the stopping distances were based on a Ford Anglia, but almost certainly wrong!
That was alluded to in this old Top Gear video - http://www.youtube.com/watch?v=KGkKDaYd3Mo

andy_s

19,400 posts

259 months

Monday 30th September 2013
quotequote all
Engineer1 said:
It's not who can't press a pedal more people panic find their seat position is such that they can't push it to the floor or just fear the feeling of lack of control when the total available braking force is applied.
I guessed that's what you meant, but that's why they brought ABS in so that people didn't lock up. Still, if it helps some...

GT6k

859 posts

162 months

Monday 30th September 2013
quotequote all
A very long time ago I went around an open day at the Met police forensic labs, in the traffic section was a display on how they calibrated the skid mark length to speed calculations. This involved renting/borrowing a variety of cars from a Ferrari to an Escort and then doing emergency stops from various speeds. Strangely there seemed to be many more photos and measurements on the Ferrari than the Escort.

jagnet

4,110 posts

202 months

Monday 30th September 2013
quotequote all
Engineer1 said:
It's not who can't press a pedal more people panic find their seat position is such that they can't push it to the floor or just fear the feeling of lack of control when the total available braking force is applied.
yes

Daily driving is normally an exercise in avoiding heavy braking, so when the time comes to actually stand on the brakes as hard as possible, very few people are geared up to do so.

Having spent a couple of days on one of Rob Gravett's driving courses, I think everyone there without exception put their hands up to braking far harder by the end of it than at the beginning, despite their best intentions to brake as hard as possible from the outset. That was only achieved through many repeated hard stops. Definitely something of an eye opener.


watchnut

1,166 posts

129 months

Tuesday 1st October 2013
quotequote all
The HWC says that to stop from 30 mph you require 6 car lengths, 75 feet, or 23 metres

when i cover emergency stops in my Corsa I explain that the distances printed are not what they will do when we do a stop from 30 mph, but, and a BIG BUT....there are cars out on the roads that still require those distances to stop owing to the age of the car and the type of brakes that they have along with the type of tyre on the wheels. I think that an old 100 year old steam car, or VW beetle camper van/car may well take a country mile to slow (especially if the driver is drunk/on drugs!

On a good surfaced road, with decent tyres on, in the dry, with a 17 year old kid at the wheel......expecting to to have to do an emergency stop they can stop my car from 30 mph in about 1 and a half to 2 car lengths.....proving that the printed word is not always right.

But, on a cold wet night, in rain, with tyres less than 3mm, that are under infalted/over inflated, on a poor surface with a little standing water, being distracted by a girlfriend touching him up, with a couple of pints in him, and 0n a "promise" at her house....I guess the drunk lad standing in the road, just around the bend in dark clothing has had it

For many people when i ask them if they think ABS will stop them quicker than a car with out ABS, many feel it will, but they could be very wrong as in some cases ABS will make the car stop over a longer distance. ALL ABS does is provide more steering control whilst the car is skidding in the majority of cases.... I have had a couple of cases where taking out "older" drivers who are "pre ABS" trained when they have braked hard enough for the ABS to kick in they have done the last thing they should and released the brake pedal as they believed that the brakes had "broken or something" owing to the grinding/noise/vibration through the wheel/pedals/and seat.......Most people have never done a decent brake test on their car to see how it reacts under heavy stressful braking to see how it pulls to one side or the other. ( Please if you are going to do this, make sure the road is very clear behind you, and you do it from low speeds upto a speed you can still keep control of your vehicle.....the driving test is set at a speed of upto 30 mph for safety reasons......I do not condone/suggest this is for everyone to do, if you do you do so at your own risk!)
RTFM...read the flipping manual......for your car, and only drive at a speed you can safely stop in the distance you can see to be clear in front of you......and you should never have to do an emergency stop.....simples !



Edited by watchnut on Tuesday 1st October 20:56

RenesisEvo

3,608 posts

219 months

Tuesday 1st October 2013
quotequote all
jagnet said:
Having spent a couple of days on one of Rob Gravett's driving courses, I think everyone there without exception put their hands up to braking far harder by the end of it than at the beginning, despite their best intentions to brake as hard as possible from the outset. That was only achieved through many repeated hard stops. Definitely something of an eye opener.
I did one of Rob's courses, and thoroughly concur with your points. I recall the instructor demanding the ABS kicking in every single time, it really took some re-calibration of expectations to achieve it. The brakes were smoking when I climbed out! I use the brakes very lightly and very little generally, so on a recent track day experience it took a while to again build up the confidence to really lean on the brakes. I thought I was braking sharply, but later I realised I was nowhere near full stopping power. Even with little wiggles on the way into one corner.

I think the brake assist is a good idea, but I do wish manufacturers wouldn't over-servo the brakes so they ramp up so sharply, so early in the pedal. It makes being progressive and modulating the brakes smoothly much more challenging. The reverse means getting into an older car gives the impression of poor brakes, but actually you just need to lean on the pedal a bit harder, it will stop just as well.

I can't remember who told me (ADUK member I think), but they did suggest practicing an emergency stop every now and again (when it's safe to do so!) - wise words IMO.

Zombie

1,587 posts

195 months

Tuesday 1st October 2013
quotequote all
There's reference made in MfS 2 to a Mondeo being able to stop from 30mph in something like 7.3m (excluding reaction time) with a peak decel of 1.25g.

Thing is, it's not really about how fast you can stop, more about how fast the HGV behind you can...

John145

2,447 posts

156 months

Wednesday 2nd October 2013
quotequote all
andy_s said:
That's reassuring. Who can't press a brake pedal?
In my experience, about 80% of people I train will not brake hard enough to trigger the ABS in dry conditions without practicing.

John145

2,447 posts

156 months

Wednesday 2nd October 2013
quotequote all
andy_s said:
That's reassuring. Who can't press a brake pedal?
In my experience, about 80% of people I train will not brake hard enough to trigger the ABS in dry conditions without practicing.

chris182

4,160 posts

153 months

Wednesday 2nd October 2013
quotequote all
John145 said:
andy_s said:
That's reassuring. Who can't press a brake pedal?
In my experience, about 80% of people I train will not brake hard enough to trigger the ABS in dry conditions without practicing.
I remember reading a figure somewhere that the force on the brake pedal required to give maximum braking/activate ABS was about 35kg. If this is true then that is a lot of force, enough for a smaller person to start pushing themselves up out of the seat.

I understand to a point, I have this irrational idea that if I gave everything I have to pushing the pedal it would break or something, even though I know this isn't the case.

RenesisEvo

3,608 posts

219 months

Wednesday 2nd October 2013
quotequote all
chris182 said:
I remember reading a figure somewhere that the force on the brake pedal required to give maximum braking/activate ABS was about 35kg. If this is true then that is a lot of force, enough for a smaller person to start pushing themselves up out of the seat.

I understand to a point, I have this irrational idea that if I gave everything I have to pushing the pedal it would break or something, even though I know this isn't the case.
Consider that an F1 driver can push 120kg+ when they hit the brakes - but that's easier when you have 4-5G on your body weight, you're an athlete and you're properly strapped in.

Having designed brake pedals (for a Formula Student car) in the past, it is quite surprising how little steel you need to make something that can resist more than 100kg of load (I can't remember the loading I used, but it was something like the full weight of the heaviest person we could get in the car, then a safety factor on top). Add the necessary fatigue life for the millions of duty cycles, and in my mind you end up not far from what you get in a road car. In some cases, I'd prefer a bit more stiffness to the pedal box to improve the feel.

MC Bodge

21,628 posts

175 months

Thursday 3rd October 2013
quotequote all
John145 said:
andy_s said:
That's reassuring. Who can't press a brake pedal?
In my experience, about 80% of people I train will not brake hard enough to trigger the ABS in dry conditions without practicing.
80%?! Who are you training and what are you teaching them?

I'm possibly not a typical driver, but even when I was learning to drive, I remember initially locking-up the wheels (no ABS on 1.0 Polos 20 years ago) when practising an emergency stop.

My mother (possibly more typical of a UK driver) possibly wouldn't though.


As somebody referred to above, I do often do an ABS-inducing brake test in cars I drive. It can also help to firm up the pedal (as can pressing the pedal right down when static).

Edited by MC Bodge on Thursday 3rd October 22:48