Scalextric.......Has anyone ever?

Scalextric.......Has anyone ever?

Author
Discussion

Roadru77er

Original Poster:

473 posts

196 months

Thursday 9th December 2010
quotequote all
Is it possible or has anyone heard of/built a set-up on a garage floor that can be driven/parked on. Or possibly covered over and driven/parked on?

IainZ

12,298 posts

207 months

Thursday 9th December 2010
quotequote all
Roadru77er said:
Is it possible or has anyone heard of/built a set-up on a garage floor that can be driven/parked on. Or possibly covered over and driven/parked on?
No, but I built one that could be winched up to the ceiling hehe

IanMorewood

4,309 posts

249 months

Thursday 9th December 2010
quotequote all
No compressing the track is not a good idea at all. The only solution I can think of right now would involve recessing the track and then covering it over with something solid.

Other solutions would involve a wall or ceiling hung drop down layout or building it in the garage roof space (assuming you don’t have a flat garage roof).

Mr E Driver

8,542 posts

185 months

Thursday 9th December 2010
quotequote all

+

=

russy01

4,693 posts

182 months

Thursday 9th December 2010
quotequote all
Erm no, not going to work. Track is too soft. Start track is tougher but it still won't work.

8x4 board chuck some hinges on the wall and you're done.

Roadru77er

Original Poster:

473 posts

196 months

Friday 10th December 2010
quotequote all
I was thinking along the routered board on the floor or recessing the track into a board so it's flush. Not that it makes much difference it's only a light car to be parked on it(Caterham)

roblees

60 posts

220 months

Saturday 11th December 2010
quotequote all
You could always hinge the board in two lengthwise so that when folded it's narrower than the track of your Caterham (but lower than its ground clearance). Then you just drive over the resulting plank using your finely honed car placement skills. Any fluids leaking off the car would then hit the back of the layout not the track surface. When you want to race slot cars, reverse the big car out of the garage and put up your slot car track.

But you'd still end up with a track that's going to get grubby and unpleasant quite quickly.

We use 8 x 4 boards halved to make 4 x 4 sections which stack easily against a wall. Ikea legs are £2 each and screw in quickly so on a club night at Marlborough we can get a 20 x 8 track up in minutes. We currently use plastic track pinned to the boards but routing is a very good option. As already said hinging off a wall and hanging from the beams are good options.

Check out the British Slot Car Racing Association website for more info and clubs near you.

Best Rob

Edited by roblees on Saturday 11th December 10:17