Lazy passenger door locking on VXR8

Lazy passenger door locking on VXR8

Author
Discussion

SteveMJ

Original Poster:

919 posts

196 months

Saturday 6th February 2016
quotequote all
My VXR8's door lock is a bit slow to lock or unlock. Usually a couple of attempts makes it finish its job.

As the replacement mechanism is £175, I am keen to look for a lower cost fix.

I am assuming that either the mechanism has worn or the solenoid has bad electrical contacts or it gets full or crud. Has anyone any experience and may be able to cast some expertise on this?


I am guessing (car is in garage being serviced) that this is only a few pressed steel and nylon parts operated by a solenoid, so not a lot involved and probably common with other GM vehicles.

Thanks, Steve

theswisstime

29 posts

142 months

Saturday 6th February 2016
quotequote all
Happened to my drivers door ended up setting the alarm off through the night.

I managed to get a Pontiac g8 door lock for £38 from the states. Worth doing a search online. Quite easy diy fit too.

mik_ok

1,568 posts

241 months

Saturday 6th February 2016
quotequote all
I've had issues with both rear doors. See HERE

Lubricating helps for a while, but the issue returns.

I've had two new lock units (with new solenoids) sitting in the garage for over a year now ready to fit - but I've got into a standard routine of 3-presses (lock, unlock, lock (parp!)) when I leave the car, and this does the job.... Hence my laziness fitting new units... whistle