SRAM X0 install / removal help.
Discussion
Hi,
We removed my mates SRAM X0 crank earlier today to fit a smaller chainring but had difficulties With the reinstallation - we've tried google, YouTube etc. but they only seem to show guides for the systems with the 8mm writhin the 10mm nut.
The ones we have have a 10mm both sides with the drive side being the one to remove that self extracts, the other side has a 10mm hex but says do not remove.
On reinstallation we have torqued it to 54 Nm but have ended up in lateral movement / end float.
It has a preload system on the non drive side, we have tightened this which stops it but after a while this works loose.
We have about 2mm of play, looks like it could do with a shim but we didn't take any out.
Any thoughts?
Currently in the middle of the Peak District - may have to find a shop somewhere in the Hope Valley if anyone has any recommendations?
We removed my mates SRAM X0 crank earlier today to fit a smaller chainring but had difficulties With the reinstallation - we've tried google, YouTube etc. but they only seem to show guides for the systems with the 8mm writhin the 10mm nut.
The ones we have have a 10mm both sides with the drive side being the one to remove that self extracts, the other side has a 10mm hex but says do not remove.
On reinstallation we have torqued it to 54 Nm but have ended up in lateral movement / end float.
It has a preload system on the non drive side, we have tightened this which stops it but after a while this works loose.
We have about 2mm of play, looks like it could do with a shim but we didn't take any out.
Any thoughts?
Currently in the middle of the Peak District - may have to find a shop somewhere in the Hope Valley if anyone has any recommendations?
Gassing Station | Pedal Powered | Top of Page | What's New | My Stuff