Crossram build
Discussion
Mine sat in a similar position, maybe a little bit lower. But these dimensions are controlled by the factory when they weld in the mount plates and ship rubber bobbins at a specific size.
Never seen a radiator set on such small cushions, usually they are twice that size.
Never seen a radiator set on such small cushions, usually they are twice that size.
Edited by crossram on Sunday 5th January 02:43
Edited by crossram on Sunday 5th January 17:20
donkeasy said:
How big is the hole underneath the radiator now?
Maybe you shoot bent the radiator-lips a bit!
Nope it remains where it's at, it won't make that big a difference Maybe you shoot bent the radiator-lips a bit!
Hmm I see that Ultima does have a aluminum radiator I wish I would have seen that prior to shipment. Oh well ... back to the to-do list.
Edited by crossram on Tuesday 7th January 16:40
Edited by crossram on Tuesday 7th January 16:49
Wiring, taged most of the components, a few colors off. Having sold wiring harnesses in Silicon Valley for many years I can say these are pretty good cables, terminations look sound it would save a lot of time if the manufacturer would label the harness while it's on the jig board. I guess this a test for us builders and a way to educate us on whats ahead for us in the build. However that said it's never good electrically if someone should make a mistake and get the labeling wrong.
Gassing Station | Ultima | Top of Page | What's New | My Stuff