Rear bulkhead hole sizes?
Discussion
barriejames said:
Anyone have the hole sizes for hand brake cables and right hand shift gear linkage where they pass through the rear and engine bay bulkhead? I think from CJ site the hand brake cables is 18mm cannot locate the size for the linkage.
Thanks
Hi Barrie,Thanks
The G50 selector shaft is 12mm - so a 14mm hole allows some tolerance.
For the handbrake (assuming you're using the AP/Brembo factory setup), the cable has an 11mm sheath, but, you need to be able to pass the large cable ends through the hole - the smallest of which is the 16mm diameter nipple end, which eventually attaches to the Brembo e-brake caliper.
Not sure whether you're referring to my GTR or Can-Am sites (I'm CJ by the way ), but if the info is missing from one, you can usually find it on the other
Gassing Station | Ultima | Top of Page | What's New | My Stuff