Brake motion cable route
Discussion
In a normal build, the brake pressure switch is on the rear T section. However this specific position on the rear brake circuit makes for a slowish reaction to the brake lights turning on (less pressure in the rear) so it seems.
One way to solve this problem is to install the brake pressure switch which you seem to have ordered (me too but not used).
The second way is to install the brake pressure switch in the front brake circuit. You just have to splice the necessary wires to the loom.
One way to solve this problem is to install the brake pressure switch which you seem to have ordered (me too but not used).
The second way is to install the brake pressure switch in the front brake circuit. You just have to splice the necessary wires to the loom.
Edited by UltimaCH on Friday 18th April 17:02
Gassing Station | Ultima | Top of Page | What's New | My Stuff