Discussion
I have just completed the bulkhead panel and although I am fairly satisfied with the end result, I just wanted some advice or recommendations on what other builders have used to fold the aluminium over the round chassis tube.
Looking at the panel along the top bent over section from certain angles under the garage strip light you can still see some slight waves. Is that normal or should it be flawless?
I use a wooden block and hammer to gradually bend the panel over 3 or 4 passes.
This panel is less critical than the side panels so just wanted others opinions before moving one.
Looking at the panel along the top bent over section from certain angles under the garage strip light you can still see some slight waves. Is that normal or should it be flawless?
I use a wooden block and hammer to gradually bend the panel over 3 or 4 passes.
This panel is less critical than the side panels so just wanted others opinions before moving one.
Edited by sukhjeevan on Monday 6th October 09:50
Gassing Station | Ultima | Top of Page | What's New | My Stuff