Dash layout

[sukhjeevan]

Planning my own dash layout and hope to knock something up in AutoCad before having it 3D printed.

I'm quite away off ordering my body and was hoping to get some dash measurements. Would anybody be kind enough to supply me with some measurements?

I just need the length and width of the flat section of the dash face, along with the location of the steering column hole.


Any help would be greatly appreciated.

[UltimaCH]

Let me get back to my workshop and knock up some measurements for you...

[UltimaCH]

Length of the dash on the flattish side is 750-760mm
Width at the center is 160mm
Distance between a central vertical line and the steering column is 250mm

Measurements are approximate to a couple of mm

Photo below of my dash mock-up.

[sukhjeevan]

Perfect. Thanks!

[Steve_D]

UltimaCH said:

.....Photo below of my dash mock-up.

Is that the Factory cowl for a Stack Dash?
If so I found that I needed to extend the 'Peek' to get rid of glare on the windscreen at night.

Steve

[UltimaCH]

Yes it's the factory supplied cowl. Thanks for the tip.

[sukhjeevan]

Hi,

Can I also have the vertical distance from the top of the dash to the centre of the steering column hole please?

I also need the diameter of the rubber boss that fits around the column.

That will give me everything I need to complete my design!

Any measurements will be greatly appreciated.

[UltimaCH]

Glad to give you some measurements, but you'll have to wait until after the 22nd. I'm away from the workshop until then.
Cheers
Daniel

[sukhjeevan]

Very much appreciate Sir!