Ride Height Bar kit location?

Ride Height Bar kit location?

Author
Discussion

Corsair613

Original Poster:

260 posts

121 months

Thursday 13th November 2014
quotequote all
Can anyone with a recent kit tell me where (which box) the right height bars were packed? I've been all through mine and can't find those bars.

It's possible (though unlikely) that I've overlooked them somewhere, but I thought I'd ask here while waiting to hear back from Ultima before tearing through all the boxes yet again.

Where would you be if you were a set of ride height bars?

Ken

barriejames

895 posts

178 months

Thursday 13th November 2014
quotequote all
Ride height bars not supplied with the kits now, they weren't with mine anyhow, sure I asked and told not supplied now.

Corsair613

Original Poster:

260 posts

121 months

Thursday 13th November 2014
quotequote all
barriejames said:
Ride height bars not supplied with the kits now
OK, well there you go. Wish that had been noted somewhere on the build CD which calls out their use. Shall I simply build up each corner using the actual shocks, then? If so, at what setting?

I've had the body pre-fit, if that makes any difference.

Ken

Rscocca

127 posts

123 months

Thursday 13th November 2014
quotequote all
according to factory if you get the body pre fit they do not supply the bars to replace shocks.
I have the measurements at the office , Ill post them in the morning

Corsair613

Original Poster:

260 posts

121 months

Thursday 13th November 2014
quotequote all
Rscocca said:
according to factory if you get the body pre fit they do not supply the bars to replace shocks.
I have the measurements at the office , Ill post them in the morning
Thanks; much appreciated!

Ken

Steve_D

13,737 posts

257 months

Friday 14th November 2014
quotequote all
Measurement between hole centres
Front 296
Rear 314

Steve

Rscocca

127 posts

123 months

Friday 14th November 2014
quotequote all
Steve beat me to it.

Corsair613

Original Poster:

260 posts

121 months

Friday 14th November 2014
quotequote all
Thanks; much appreciated! I'll use those measurements as a starting point.

Ken