Factory Body Fit
Discussion
GtrMan said:
Is it that hard to do the body fit , would like to hear some feed back who did it .
Not hard to do just requires time, patience and attention to detail.You can't fit the panels one at a time you need to pretty much assemble them all together so you can tweak each to achieve the correct fit.
Steve
GtrMan said:
Is it that hard to do the body fit , would like to hear some feed back who did it .
I did mine initially.. Very awkward especially if you want to truly do it alone.As Steve say ... attention to detail. The car is not symmetrical so what you do on one side isn't necessarily what you will do on the other side.
I think it took me about 4 weeks to get the body right in the end so you need to have patience ............... and lots of thinking time about it, this is not an airfix kit lol.
Once I finished the car I was glad i had done the fit ... I built the car.
Dave
confusionhunter said:
I keep thinking the green cars need ZX350ci emblazened across the side, super bike style
I havent donea panel allignment but was planning on taking the back clam off, as long as I mark it should be too much bother getting it back in the right place no?
If you just remove the bolt that goes through the ball joint. Watch out for any spacer washers and replace them in the same place that they came from and you should be able to put it back in the same place. No probs...I havent donea panel allignment but was planning on taking the back clam off, as long as I mark it should be too much bother getting it back in the right place no?
Paul
Gassing Station | Ultima | Top of Page | What's New | My Stuff