Final door fit
Discussion
Hi All
I am doing the final fit of the doors. I am happy with the positioning and panel gaps, but the door requires a lot of force to close properly on the latch - to such an extent that it can be done from outside where you can push down on it, but I can't imagine it would be possible to pull it down from inside and close it properly.
I am wondering whether I need to thin out the rubber seal mating surface (which I can see that the factory have done a bit - I had them do the bodywork prefit), or wait a bit with door in place to see if the rubber seal squashes down, or both?
Thoughts welcomed!
I am doing the final fit of the doors. I am happy with the positioning and panel gaps, but the door requires a lot of force to close properly on the latch - to such an extent that it can be done from outside where you can push down on it, but I can't imagine it would be possible to pull it down from inside and close it properly.
I am wondering whether I need to thin out the rubber seal mating surface (which I can see that the factory have done a bit - I had them do the bodywork prefit), or wait a bit with door in place to see if the rubber seal squashes down, or both?
Thoughts welcomed!
Gassing Station | Ultima | Top of Page | What's New | My Stuff