CV Boots

[Racingroj]

Hi Guys
I know that you can get a VW Bora BT-177 for the outer cv joints and this has a 100mm ID for the built in flange. Does anyone know if the same type of boot is available (probably VW or Audi) with an ID of 108mm for the inner CV joints?
Thanks
Roj

[Rscocca]

try this site,
http://www.jjcraceandrally.com/race/differentials/...
I have no affiliation with them, recommended by someone else on forum before.

[Racingroj]

Thanks for the link. I spoke to the factory about this and they said they used to use the aerodynamic ones on the inside but when you jack the car up the angle was cutting the rubber boot. Anyone else used these?

[V8Dom]

Rscocca said:

try this site,
http://www.jjcraceandrally.com/race/differentials/...
I have no affiliation with them, recommended by someone else on forum before.

think that might have been me...

[V8Dom]

Racingroj said:

Thanks for the link. I spoke to the factory about this and they said they used to use the aerodynamic ones on the inside but when you jack the car up the angle was cutting the rubber boot. Anyone else used these?

they are fine,....just dont rotate wheel jacked up.... if needed support sus arm...dom