Stripped thread!
Discussion
Stripped a thread in LS7 block changing exhaust manifold as it had a leak. The last one too! - all others done up to 15ft lbs.
I've re-threaded it but its still not quite good enough to get 15 ft lbs. Got it to about 12 then it starts spinning again.
Is a thread insert my best option?
Mark
I've re-threaded it but its still not quite good enough to get 15 ft lbs. Got it to about 12 then it starts spinning again.
Is a thread insert my best option?
Mark
Mark,
Are using the full depth of the threaded hole in the cylinder head? Could you use a longer bolt to pick up a good part of thread deeper down or potentially make a stud that screws into the head fully then use a nut? Is all the thread stripped?
Might be worth trying this otherwise a M8 helicoil would be the solution,.
KR's
Are using the full depth of the threaded hole in the cylinder head? Could you use a longer bolt to pick up a good part of thread deeper down or potentially make a stud that screws into the head fully then use a nut? Is all the thread stripped?
Might be worth trying this otherwise a M8 helicoil would be the solution,.
KR's
Gassing Station | Ultima | Top of Page | What's New | My Stuff