Discussion
I'm almost there, suspension set up, to do and bits and bobs over the winter.
what have you guys done about a surround at the point the rear brace goes through the body, I'm thinking of having an anodised aluminium part machined.
I just bought a Gopro so a short video of the car.
https://youtu.be/xsexxqaBWxU
what have you guys done about a surround at the point the rear brace goes through the body, I'm thinking of having an anodised aluminium part machined.
I just bought a Gopro so a short video of the car.
https://youtu.be/xsexxqaBWxU
go to summit racing look under grommets. The product name is seals it, grommet seals. This is a advantageous place to seal the interior from the engine compartment. I didn't pick up on this one until the car was on the road for a bit makes a big difference. I like this product because it allows the movement between the roll bar and the body which occurs. Lee
Thanks Lee I've been searching for something suitable for a while.
I was thinking of sandwiching a rubber gasket between the ally so i would have a seal. I've seen something similar recently, on a Red car I think, but the alloy plate was a bit chunky for my tastes.
I'll look at the grommet, I'll also cost out my idea, anodised Black would be nice.
Rgds
David
I was thinking of sandwiching a rubber gasket between the ally so i would have a seal. I've seen something similar recently, on a Red car I think, but the alloy plate was a bit chunky for my tastes.
I'll look at the grommet, I'll also cost out my idea, anodised Black would be nice.
Rgds
David
Gassing Station | Ultima | Top of Page | What's New | My Stuff