Christmas Present
Discussion
I'm just about to order another load of bits, which should keep me busy for a while. That's a Christmas present to myself.
Also just bought some basic track time with an Ultima ( on ebay ) for me and the Mrs. She's going to be on the insurance once mines finished, so I thought it's better if the first time she drives one it isn't mine
Also just bought some basic track time with an Ultima ( on ebay ) for me and the Mrs. She's going to be on the insurance once mines finished, so I thought it's better if the first time she drives one it isn't mine
Santa list is endless, Still thrashing out detail, my build need lots of different things as not quite a simple build, but set of centre lock hubs for wheels i have once car is finished are on list, lots of parts still to get from factory and some fabrication of many one off parts wish i had a little helper not been on here for while busy with lots of things ,like to wish all a very merry xmas and happy new year when it arrives and i shall post some pictures of my build in the new year all the best Benny TDV6 ULTIMA
Rscocca said:
MacG racing front and rear suspension arms, rims and uprights
and an Albins 6 speed with air shift paddles
Santas being nice to me this year.
Bloody hell! You must have been very 'nice' to santa to get all those bits! Is santa also setting up the airshift / trans for you as well? Is this a track or road car? Also, didnyou strech to their AP brakes as well?.....and an Albins 6 speed with air shift paddles
Santas being nice to me this year.
The Ultima goes out of service for a motec upgrade. We are changing from a 800 series Motec to a 130. The 100 series are the latest Motec offering. the reason for the change is I am adapting two electronic throttle bodies to work as actuators only. Each actuator will run one bank of the kinsler ITBs. One side will be master and the second side will be trimmed to the first by the ECU. All of this is because of a problem we have encountered with the Kinsler. What this will also allow me to do is employ traction control and allow for better idle control. We will also be able to slow the throttle response off idle so that the input/ output is non linear. Merry Christmas to all
by the way the Motec 800 will be up for sale. Lee
by the way the Motec 800 will be up for sale. Lee
From Ultima: Replacement throttle cable (for mechanical throttle body), face vent kit, replacement side screen vents, brake light pedal motion switch kit (to replace the fluid pressure switch), longer steering rack arms and upright steering arms (I already have custom control arms that are longer and with these bits I can remove extensions), larger battery bracket, replacement door lift support strut.
From MacG Racing: bump steer kit.
@perth-evo: I highly highly highly suggest you don't use the factory LS7 fuel system as I can see. Mine was nothing but problems (clogged with baffling, then the valve stopped switching all together, etc), so I replaced it with a balance pipe and twin pump system. I see you've riveted the sidepods on now, but they're still a LOT easier to remove now rather than later when the body is on. I suggest to remove your tanks and weld a -12 on the bottom of it for the balance pipe now, especially with the engine not being in yet.
My 2c anyway. I'm based in Melbourne if you want my number to give me a call.
My 2c anyway. I'm based in Melbourne if you want my number to give me a call.
perth-evo said:
Hi AlexCim, thanks for your suggestions. I have seen quite a few threads about this but believe (in my naivety?) that the factory set up has improved significantly over the last year or so. I may live to regret it but am building the car to their spec. Thanks again
Really what's changed?Gassing Station | Ultima | Top of Page | What's New | My Stuff