(Not so) Quick Headlight cover question
Discussion
When I picked up the Ultima both headlight covers had been removed.
One headlight had had the margin around the lights scraped back to red gel coat, the other side was mostly black.
The perspex light covers were completely clear around the edge.
Anyway, the question is how are they normally attached so you cannot see the adhesive?
I have thought of painting the margins black and then use a little black silkoflex,
or paint them red and use clear silicone,
or screw them on with some nice fixings.
But I was hoping you guys might point me in the right direction?
Many thanks
Ed
ps or perhaps Ultima sell the perspex covers with coloured margins??
One headlight had had the margin around the lights scraped back to red gel coat, the other side was mostly black.
The perspex light covers were completely clear around the edge.
Anyway, the question is how are they normally attached so you cannot see the adhesive?
I have thought of painting the margins black and then use a little black silkoflex,
or paint them red and use clear silicone,
or screw them on with some nice fixings.
But I was hoping you guys might point me in the right direction?
Many thanks
Ed
ps or perhaps Ultima sell the perspex covers with coloured margins??
You need this for the black margin, use a tape that doesn't bleed, I used modeling tape from a model shop.
Link.
https://www.silmid.com/search-results/?searchterm=...
Link.
https://www.silmid.com/search-results/?searchterm=...
Gassing Station | Ultima | Top of Page | What's New | My Stuff