Woodburning Stove in place of hideous gas fire

Woodburning Stove in place of hideous gas fire

Author
Discussion

MonkeyBusiness

3,936 posts

187 months

Thursday 9th October 2014
quotequote all
beeej said:
from:


to:


via:

That looks great. Was it a pain to get all the pointing done on the brickwork?

vxsmithers

716 posts

200 months

Thursday 9th October 2014
quotequote all
juice said:
vxsmithers said:
Would that meet regs? I was told I had to have a hearth, and its very similar to that except it does go down to floor level.

Looks lovely
Has to be more than 9" above the floor apparently to forgo one (ours is, luckily). It's from these guys http://www.bespokefireplacedesigns.co.uk/

Edited by juice on Thursday 9th October 16:53
Ahh I see, that would have been a royal pita to do with mine

longshot

3,286 posts

198 months

Thursday 9th October 2014
quotequote all
Simpo Two said:
beeej said:
I'm not normally a worrier but I wouldn't want logs leaning against the outside of the stove.
Most of then are leaning against the legs not the burner and the outside face doesn't get hot enough to ignite anything.

beeej

1,400 posts

193 months

Thursday 9th October 2014
quotequote all
Wot longshot sed. A burner like this gets hot at the front and the top, but not 90% of the sides. Otherwise I wouldn't do it.

The pointing was easy enough - the guy who did it scraped out anything that looked dried out and crumbling. He found some metal fixings, they look like pot hangers, so we asked him to keep them in there. That's how we hang the tools.

I plan to take the plaster off the rest of the wall, I think I should have had it all back to brick originally.


Edited by beeej on Thursday 9th October 18:16

russ_a

4,578 posts

211 months

Thursday 9th October 2014
quotequote all
longshot said:
Most of then are leaning against the legs not the burner and the outside face doesn't get hot enough to ignite anything.
I thought that too, until the logs set on fire. Was just going to bed too!!

FlipFlopGriff

7,144 posts

247 months

Friday 10th October 2014
quotequote all
Any work requires building regs approval, document J. There are strict rules on the flue, hearth size and depth, distance from flammables etc. Anything over 5kw needs vents and the vent sizes are ridiculous. More here:
http://www.stovesonline.co.uk/stove_building_regul...
See section under stove installation for the details.
FFG

juice

8,534 posts

282 months

Tuesday 14th October 2014
quotequote all
vxsmithers said:
juice said:
vxsmithers said:
Would that meet regs? I was told I had to have a hearth, and its very similar to that except it does go down to floor level.

Looks lovely
Has to be more than 9" above the floor apparently to forgo one (ours is, luckily). It's from these guys http://www.bespokefireplacedesigns.co.uk/

Edited by juice on Thursday 9th October 16:53
Ahh I see, that would have been a royal pita to do with mine
How much was your fire just out of interest, just got quoted 5.5K to have it installed which made me wince a little. Have no idea if that's well off the mark or reasonable ?

beeej

1,400 posts

193 months

Tuesday 14th October 2014
quotequote all
Well I got it done for ~2k so I'd say 5k has a healthy profit in it. Got a cost breakdown? You might want to get the stove yourself from stovesonline.co.uk, they are the cheapest I found anywhere (assuming you want scandinavian, not some a cheap and fugly pot belly).

juice

8,534 posts

282 months

Tuesday 14th October 2014
quotequote all
Problem is - it's not a standard size...which could explain why it's so chuffing expensive...frown

900mm wide x 970mm high x 457mm deep

dickymint

24,345 posts

258 months

Tuesday 14th October 2014
quotequote all
juice said:
Problem is - it's not a standard size...which could explain why it's so chuffing expensive...frown

900mm wide x 970mm high x 457mm deep
Sort the aperture out with a local builder first?


Olivera

7,146 posts

239 months

Tuesday 14th October 2014
quotequote all
What's the consensus then on gas or electric fires? Are they all naff or is it possible to get one that looks acceptable?

juice

8,534 posts

282 months

Tuesday 14th October 2014
quotequote all
dickymint said:
Sort the aperture out with a local builder first?
Yep - good point, gotta be easier to make the fireplace fit the fire, than the other way round !

Basil Brush

5,083 posts

263 months

Tuesday 14th October 2014
quotequote all
Olivera said:
What's the consensus then on gas or electric fires? Are they all naff or is it possible to get one that looks acceptable?
Some of the gas stoves look ok, if you want the look without the upkeep.

captainzep

13,305 posts

192 months

Wednesday 15th October 2014
quotequote all
beeej said:
Well I got it done for ~2k so I'd say 5k has a healthy profit in it. Got a cost breakdown? You might want to get the stove yourself from stovesonline.co.uk, they are the cheapest I found anywhere (assuming you want scandinavian, not some a cheap and fugly pot belly).
Couple of words of warning buying online from personal experience.

(1) I didn't order from stoves direct -they may be fine, but I ended up having to reclaim costs through my credit card company for a stove that never materialised from another online firm that seemed legit. The wholesale business can be pretty cut throat and things don't always go well. In the end I went to a local shop and bought the actual stove I looked at played around with. Got a decent price too as an ex-demo .

(2) Ordering a stove from an online picture can lead to mistakes. Following on from above, -having seen one I liked I went to look at it in the flesh and realised it just wouldn't look right in the house. Additionally it had a slightly bevelled top meaning a kettle wouldn't sit on it flat. I picked another which fits the style of the house better whilst providing cups of tea and casseroles!

-Not saying there aren't great deals out there, (and my instinct is to always get lowest price on internet), but going local and seeing the stove in the flesh was the right thing to do for us.