Flat warm roof insulation
Discussion
richard at home said:
If I might resurrectI've ended up with virtually the same make up as Richard, other than copper as the top coat.
10 deg pitch, softwood rafters, 11mm OSB 2, VCM, 120 PIR, 18mm OSB. I have a contractor laying the copper on this.
I have all the materials other than the fixings, which I would like to order today.
There seems to be a few options, nails, screws etc. Spax seem well reviewed, but have flat head and countersunk and various other options.
Any advice on what and how many, amateur instal? It comes out at 45 sq. metres.
Thanks
C Lee Farquar said:
If I might resurrect
I've ended up with virtually the same make up as Richard, other than copper as the top coat.
10 deg pitch, softwood rafters, 11mm OSB 2, VCM, 120 PIR, 18mm OSB. I have a contractor laying the copper on this.
I have all the materials other than the fixings, which I would like to order today.
There seems to be a few options, nails, screws etc. Spax seem well reviewed, but have flat head and countersunk and various other options.
Any advice on what and how many, amateur instal? It comes out at 45 sq. metres.
Thanks
I had these delivered yesterday...................I've ended up with virtually the same make up as Richard, other than copper as the top coat.
10 deg pitch, softwood rafters, 11mm OSB 2, VCM, 120 PIR, 18mm OSB. I have a contractor laying the copper on this.
I have all the materials other than the fixings, which I would like to order today.
There seems to be a few options, nails, screws etc. Spax seem well reviewed, but have flat head and countersunk and various other options.
Any advice on what and how many, amateur instal? It comes out at 45 sq. metres.
Thanks
https://www.screwfix.com/p/fastenmaster-flat-struc...
My roof will be "thinner" than yours as i've opted for
Joists
SuperQuilt
Firrings
18mm OSB3 T&G
75mm PIR
18mm OSB3 T&G
GRP
And for any doubters out there my Building Control (indie) was dubious about using SuperQuilt as he wanted 175mm PIR He changed his mind when I gave him copies of the manufacturers certification, installation method and U value calculations.
I did look at these "nails"....................
https://www.ancon.co.uk/products/wall-ties-restrai...
Anybody used them? Thoughts?
https://www.ancon.co.uk/products/wall-ties-restrai...
Anybody used them? Thoughts?
Gassing Station | Homes, Gardens and DIY | Top of Page | What's New | My Stuff