Marussia Manor auction
Discussion
s3fella said:
A friend has just been over here, he went to the viewing on Friday and they were apparently charging £25 a head to go and view the stuff.
£25 for a Catalogue which admits two. The £25 is refunded against any purchase over £25. Basically to stop civilians cluttering up the place trying to take selfies next to a half fooked 2012 tub So we went today...... My word a lot of stuff has gone out the back door since September!
Very little decent usable kit left, some measuring stuff and the odd test rig but very few people need a home brew brake test rig or a hydraulics test rig that's worse than ours (which we pilfered out of Brawn and it was three years old then!).
A lot of brightly coloured bodywork, some plastic pigs (identifed as rolling chassis in the catalogue!) and a st load of hats, clothing and IT equipment. Nearly everything else that was a car part was well out of life and anything else decent went to Russia (and we're not sure if it's returning).
No listas full of wiggins, symetrics or AS connectors
Still if anyone does buy a car we have three CA engines in stock, ready to roll..... just make sure you get a complete gearbox as well as what was on the rollers didn't appear to be!
Very little decent usable kit left, some measuring stuff and the odd test rig but very few people need a home brew brake test rig or a hydraulics test rig that's worse than ours (which we pilfered out of Brawn and it was three years old then!).
A lot of brightly coloured bodywork, some plastic pigs (identifed as rolling chassis in the catalogue!) and a st load of hats, clothing and IT equipment. Nearly everything else that was a car part was well out of life and anything else decent went to Russia (and we're not sure if it's returning).
No listas full of wiggins, symetrics or AS connectors
Still if anyone does buy a car we have three CA engines in stock, ready to roll..... just make sure you get a complete gearbox as well as what was on the rollers didn't appear to be!
poppopbangbang said:
No listas full of wiggins, symetrics or AS connectors
I saw a couple of small trays of Symetrics in one of the cabinets in the Hyds room and some on the end of hoses/hardlines but that was all. Some guy was eyeing them up saying they sell well on eBay?!Do you service yours yourselves?
Cagey said:
I saw a couple of small trays of Symetrics in one of the cabinets in the Hyds room and some on the end of hoses/hardlines but that was all. Some guy was eyeing them up saying they sell well on eBay?!
Do you service yours yourselves?
There used to be two listas full of them in hydraulics, they've all "gone" somewhere! IIRC Engine kit used to have a pretty decent selection too, again they've "gone" somewhere. Most disapointing! We have pretty good stocks but there are some which we are running low on (dash 3s mainly).Do you service yours yourselves?
We service them in house, they're everywhere on our stuff and we don't have the budget to pitch them back for someone else to do
Edited by poppopbangbang on Monday 15th December 22:14
Gassing Station | Formula 1 | Top of Page | What's New | My Stuff