Discussion
I'll upload a photo of my install when I get a moment - it's very tidy I would say and minimal wires but I do have it fixed v close to the top of the screen rather than a few inches down (I have no rear view mirror for it to be housed behind).
I've got a problem with my power lead though - it's fallen apart at the cig lighter end. Does anyone know what sort of lead it is? Guessing its just a 12A > 5A converter lead to mini USB port?
I've got a problem with my power lead though - it's fallen apart at the cig lighter end. Does anyone know what sort of lead it is? Guessing its just a 12A > 5A converter lead to mini USB port?
Shnozz said:
I'll upload a photo of my install when I get a moment - it's very tidy I would say and minimal wires but I do have it fixed v close to the top of the screen rather than a few inches down (I have no rear view mirror for it to be housed behind).
I've got a problem with my power lead though - it's fallen apart at the cig lighter end. Does anyone know what sort of lead it is? Guessing its just a 12A > 5A converter lead to mini USB port?
I got a spare lead because we have three cars, and the camera is swapped between two of them.I've got a problem with my power lead though - it's fallen apart at the cig lighter end. Does anyone know what sort of lead it is? Guessing its just a 12A > 5A converter lead to mini USB port?
http://www.amazon.co.uk/dp/B00EH3GRNK/ref=wl_it_dp...
chris watton said:
I got a spare lead because we have three cars, and the camera is swapped between two of them.
http://www.amazon.co.uk/dp/B00EH3GRNK/ref=wl_it_dp...
Cheers Chris (my guru on this thread!).http://www.amazon.co.uk/dp/B00EH3GRNK/ref=wl_it_dp...
It's quite annoying as I hardwired the original lead through the dash (took my entire dash top off and ran it through the wires and air vents underneath!).
Either I embark on a massive project of taking it all apart again or just run it under the dash as neatly as possible ! I don't like mess (OCD about neatness of design!!).
Shnozz said:
Cheers Chris (my guru on this thread!).
It's quite annoying as I hardwired the original lead through the dash (took my entire dash top off and ran it through the wires and air vents underneath!).
Either I embark on a massive project of taking it all apart again or just run it under the dash as neatly as possible ! I don't like mess (OCD about neatness of design!!).
I am the same, I hate wires trailing all over the dash - I had it hard wired into the Mini and my Tamora - and managed to hide the wire myself for my wife's MG.It's quite annoying as I hardwired the original lead through the dash (took my entire dash top off and ran it through the wires and air vents underneath!).
Either I embark on a massive project of taking it all apart again or just run it under the dash as neatly as possible ! I don't like mess (OCD about neatness of design!!).
Mini 0801
Genuine Power Magic Pro
x2 Add-a-circuits
This will give you 1080p HD rolling all the time for less than 100. Takes about an hour to install.
Here's a link to the camera: http://www.amazon.co.uk/E-PRANCE-Original-Ambarell...
Here's a link to a installation guide: http://hondakarma.com/guides/dash-cam-hardwiring-t... (there's a blue download link top right)
Here's some links to the footage of various encoding qualities, some only 720p, dull weather conditions etc. I've not uploaded any at full quality, I'll get round to it eventually as I'll need to do it in my own server space so that YouTube etc doesn't mess about with the encoding.
http://youtu.be/ZoPi1Ol9Sa8
http://youtu.be/EiOdIuhZQUE
http://youtu.be/hW7NitSMXtE
http://youtu.be/Iz4sxaufSJA
http://youtu.be/F01Yw3fbw8c
http://youtu.be/LelRlPSxato
http://youtu.be/fjzlaOT3nYM
http://youtu.be/KNNt92HK0fw
Nothing too dramatic, but you can see why I've got one! lol
Genuine Power Magic Pro
x2 Add-a-circuits
This will give you 1080p HD rolling all the time for less than 100. Takes about an hour to install.
Here's a link to the camera: http://www.amazon.co.uk/E-PRANCE-Original-Ambarell...
Here's a link to a installation guide: http://hondakarma.com/guides/dash-cam-hardwiring-t... (there's a blue download link top right)
Here's some links to the footage of various encoding qualities, some only 720p, dull weather conditions etc. I've not uploaded any at full quality, I'll get round to it eventually as I'll need to do it in my own server space so that YouTube etc doesn't mess about with the encoding.
http://youtu.be/ZoPi1Ol9Sa8
http://youtu.be/EiOdIuhZQUE
http://youtu.be/hW7NitSMXtE
http://youtu.be/Iz4sxaufSJA
http://youtu.be/F01Yw3fbw8c
http://youtu.be/LelRlPSxato
http://youtu.be/fjzlaOT3nYM
http://youtu.be/KNNt92HK0fw
Nothing too dramatic, but you can see why I've got one! lol
Shnozz said:
Cheers Chris (my guru on this thread!).
It's quite annoying as I hardwired the original lead through the dash (took my entire dash top off and ran it through the wires and air vents underneath!).
Either I embark on a massive project of taking it all apart again or just run it under the dash as neatly as possible ! I don't like mess (OCD about neatness of design!!).
Instead of plugging something like that into a lighter socket if you are taking the dash apart you might as well put one of these behind thereIt's quite annoying as I hardwired the original lead through the dash (took my entire dash top off and ran it through the wires and air vents underneath!).
Either I embark on a massive project of taking it all apart again or just run it under the dash as neatly as possible ! I don't like mess (OCD about neatness of design!!).
http://www.ebay.co.uk/itm/DC-12V-to-5V-3A-15W-Step...
I think* the cable ends you need are 'mini b USB cables'
http://www.ebay.co.uk/itm/151141351050?ssPageName=...
Arctic fire thanks not heard of those add a wire things before. How easy are those. Pity my fuse box is in the boot fml
Edited by Pesty on Tuesday 27th May 11:03
dave0010 said:
Hi guys. After reading through lots of posts and pages on here I've ordered a mini 0801 with the 32gb card option. Question though, whats the best way to power it? I don't like to cables hanging loose so I will probable drop the head lining and run the cables down the A pillars.
Check out my install guide a few posts back. You can usually run the wire behind the head liner trim where it meets the windscreen, down behind your A-Pillar and behind your glove box (or whichever side has your fuse box).Power Magic Pro and a couple of add-a-circuits from Amazon to protect your original fuse circuits. Mind to check if your fuse box is standard or mini blade. The Power Magic Pro will protect your battery from going flat.
I've just got a Mio 338 from Halfords, ex demo, it had sat in a display cabinet, all the bits, 30, which seemed very good.
It's a nice little unit, the footage is decent enough quality to make out reg numbers etc, though it is 720p rather than 1080
I've got it chucked on the screen at the moment although I am about to change cars when I'll have it wired in properly.
It's a nice little unit, the footage is decent enough quality to make out reg numbers etc, though it is 720p rather than 1080
I've got it chucked on the screen at the moment although I am about to change cars when I'll have it wired in properly.
arcticfire said:
dave0010 said:
Hi guys. After reading through lots of posts and pages on here I've ordered a mini 0801 with the 32gb card option. Question though, whats the best way to power it? I don't like to cables hanging loose so I will probable drop the head lining and run the cables down the A pillars.
Check out my install guide a few posts back. You can usually run the wire behind the head liner trim where it meets the windscreen, down behind your A-Pillar and behind your glove box (or whichever side has your fuse box).Power Magic Pro and a couple of add-a-circuits from Amazon to protect your original fuse circuits. Mind to check if your fuse box is standard or mini blade. The Power Magic Pro will protect your battery from going flat.
I have just got 2 x Mini 0801, one for my £500 weekend toy MX5, which is already fitted quick and dirty style (ignition fed cig lighter only)
If you've added the permanent live for the motion detect, I read that using the motion detect with these camera's has been shown to cause issues with the camera and it's recommended to turn it off? (I read a lot of reviews for diff ones so i could be confused!)
So is the E-PRANCE New Mini 0801 the one to get these days?
I previously had a £40 camera from Smartcam, but it was totally unreliable (even when it said it was recording, there was a good chance it wasn't) and I can't be bothered with anything temperamental this time.
ETA: never mind:
Why don't these manufacturers realise that if these cameras aren't reliable, they're a complete waste of time.
I previously had a £40 camera from Smartcam, but it was totally unreliable (even when it said it was recording, there was a good chance it wasn't) and I can't be bothered with anything temperamental this time.
ETA: never mind:
Amazon review said:
I bough this dash cam after reading other reviews. If I new then what I know now I would never have gone near the company. The dash cam itself is fine, but it didnt work. it didnt record, it didnt stay on, It turned itself off when driving.
Amazon review said:
Keeps locking up, even tried with alternative SD cards.
This is exactly what was happening to my other camera - I also tried other SD cards to no avail.Why don't these manufacturers realise that if these cameras aren't reliable, they're a complete waste of time.
Edited by monthefish on Wednesday 28th May 15:49
Might be worth looking at. Dashcam discount with flux
http://www.adrianflux.co.uk/blog/2014/05/adrian-fl...
http://www.adrianflux.co.uk/blog/2014/05/adrian-fl...
I've fitted a mobius to my car for the commute along the M4.
On it's first outing it captured two high speed undertakes followed by a 4 car 120mph race down the M4 on Monday lunchtime.
http://youtu.be/CTnbj98cFW8
On it's first outing it captured two high speed undertakes followed by a 4 car 120mph race down the M4 on Monday lunchtime.
http://youtu.be/CTnbj98cFW8
Are you sure you were close enough to the mondeo? If people are flashing you from behind and looking to undertake its probably better to back off from the car in front to allow yourself more space in case things go wrong.
Easy to say from the sofa, it's a bit different when you are there in the situation.
Easy to say from the sofa, it's a bit different when you are there in the situation.
rfsteel said:
I've fitted a mobius to my car for the commute along the M4.
On it's first outing it captured two high speed undertakes followed by a 4 car 120mph race down the M4 on Monday lunchtime.
http://youtu.be/CTnbj98cFW8
You're presumably just waiting for someone to say it also captured you doing 85 and also much less than 2 seconds from the car in front ... On it's first outing it captured two high speed undertakes followed by a 4 car 120mph race down the M4 on Monday lunchtime.
http://youtu.be/CTnbj98cFW8
Bungleaio said:
Are you sure you were close enough to the mondeo? If people are flashing you from behind and looking to undertake its probably better to back off from the car in front to allow yourself more space in case things go wrong.
Easy to say from the sofa, it's a bit different when you are there in the situation.
Easy to say from the sofa, it's a bit different when you are there in the situation.
M4cruiser said:
You're presumably just waiting for someone to say it also captured you doing 85 and also much less than 2 seconds from the car in front ...
FiF said:
It also captured a somewhat short sighted swerve into lane 1 and straight back out again.
When I eventually get off my arse and make a decision about what camera wouldn't be posting something like that tbh.
I presume you 3 are all driving gods then, lets not worry about the MLM van or OLM Mondeo driver, or the undertaking Q5 etc.When I eventually get off my arse and make a decision about what camera wouldn't be posting something like that tbh.
markmullen said:
rfsteel said:
I presume you 3 are all driving gods then, lets not worry about the MLM van or OLM Mondeo driver, or the undertaking Q5 etc.
Get upset if you want but really, it wasn't driving to be proud of was it? Certainly not something I'd happily upload onto the internet.eltax91 said:
arcticfire said:
dave0010 said:
Hi guys. After reading through lots of posts and pages on here I've ordered a mini 0801 with the 32gb card option. Question though, whats the best way to power it? I don't like to cables hanging loose so I will probable drop the head lining and run the cables down the A pillars.
Check out my install guide a few posts back. You can usually run the wire behind the head liner trim where it meets the windscreen, down behind your A-Pillar and behind your glove box (or whichever side has your fuse box).Power Magic Pro and a couple of add-a-circuits from Amazon to protect your original fuse circuits. Mind to check if your fuse box is standard or mini blade. The Power Magic Pro will protect your battery from going flat.
I have just got 2 x Mini 0801, one for my £500 weekend toy MX5, which is already fitted quick and dirty style (ignition fed cig lighter only)
If you've added the permanent live for the motion detect, I read that using the motion detect with these camera's has been shown to cause issues with the camera and it's recommended to turn it off? (I read a lot of reviews for diff ones so i could be confused!)
Gassing Station | In-Car Electronics | Top of Page | What's New | My Stuff